The Rhodes 22 Discussion Group R22 Discussion Group

The Rhodes 22 Discussion Group


< prior

Back to Month

Go to Thread

Member Picture

The Rhodes 22 Email List



Stern flush mounted stanchions/Side ports

2015-06-14; 09:50:33 EDT

Member Since

2014-05-06

Posts: 3821

I can't imagine stern rails made from aluminum and not stainless. This must 
 have been a retrofit by a very cheap owner at one time. The newer factory  
version of the stern rail has a section that allows for easy access to the 
stern  ladder. I like to sit on the gunnels, in fact I spend most of my time 
up there  unless I'm massively healing and need a toe hold in the opposing 
seat. I often  lean back against the rail for support, but I can also 
imagine sailing without  them. I say go for it and let us know what you think. 
I finished removing the side ports on RumRunner this week and found an easy 
 way to remove and clean them if anyone is interested. I have to clean the 
hull  surfaces and then I will be reinstalling them with (white) NP1. One of 
the  ports I removed had been rebedded about twenty years ago with NP1 and 
it was  extremely hard to cut loose. With a good install I'm guessing they 
will last the  life of the boat and never need to be removed and rebedded 
again.
I'm looking for an opening front port in good to excellent condition if  
anyone has a spare they would part with. I broke the hinge on one of mine. 
 
Rummy
 
 
In a message dated 6/14/2015 8:57:58 A.M. Eastern Daylight Time,  
rhodes22-list at rhodes22.org writes:

Confession:  i was the guy on the pressure washer! Who would  have thought 
the chrome would just fall off! Hahaha!
Bob (palatka).  

See the original archive post
×

Message to Webmaster:

To use your email application to send a messsage to the webmaster rather than this form, .



×

Post to the Rhodes 22 Email List:



×

Sending Post:

Your post is being sent... waiting