2015-06-18; 08:00:54 EDT
Member Since
2014-05-06
Posts: 3821
Hi Susan. Take Joe's advice first and inspect in calmer weather. Unwrap it and if it is all the way out, see if you can furl it. If it is not all the way out, see if you can pull it further out and then furl it. If the sail is indeed sitting lower in the slot, it may have come loose at the head. If it is the head of the sail the repair could be very simple or a bit more complex depending on what failed. However, you will have to lower the mast in either case. If you have spot where there is a lot of dock to work from (the furling tube has to come all the way out of the mast to make the repair) and the mast lowering system and some helprers, it is doable without hauling the boat. The head of the sail is most likely held to the furling tube with a tab on the sail that is held in place by a tang on the mast attached with a screw on each side. If this is the case, the failure could be either the screw or the tab on the sail that the screw goes through. If it is the screw, the repair is simple - just replace the screw and you should be good to go. If it is the sail, you may be able to just put the screw through the tab and go sailing or you may need someone with a heavy duty sewing machine like a sailmaker to replace the tab. I've attached two photos of the attachment point taken when we replaced our main. Here's hoping you just need a calm day and the sail will furl but in any event best of luck with the repair. Mary Lou 1991 R22 Fretless Rock Hall, MD At 08:43 PM 6/17/2015, you wrote: mainsail installation 2010 007sm.jpg mainsail installation 2010 010sm.jpgSee the original archive post