2015-06-21; 08:08:29 EDT
Member Since
2014-05-06
Posts: 3821
Well here is how I did it. In the papers I received with my new-old '76 was the famous engineer's appreciation of the Rhodes 22, which included a description of how to raise (and lower) the mast from the bow pulpit using the boom and main tackle cleated off the stern and hauling away. First time with my daughter standing on the fore deck holding the boom stable at 90 degrees it went up like a charm. Hallelujah. Now I was a master of the technique. The second time I made the mistake of letting the bottom end of the roller furling jib hang off the bow while I hoisted on the mast. My daughter was again helping me. At the crucial moment, when the mast had reached about 30 degrees and she was stabilizing the boom I asked her to c heck that the base of roller furled was not scraping on the ground. She let go of the boom to check. The boom swung out of control and so did the mast which came crashing down on the deck. Ouch. Miraculously the mast and boom were not damaged, nor the deck. The step however had twisted and pulled out the two bolts attaching it to the deck. After reassuring my now-traumatized daughter that I not she was to blame, I put the step in a vise and straightened it out. On inspecting the holes where the bolts had fitted into the hull, I could see this was not the first time they'd pulled out, which was a minor consolation. I extracted the two flanged pieces into which the bolts had been fastened, cleaned the holes, poured in acetone to dry out any water that might have leaked in, and then re-bedded the flanges in epoxy and let them dry. Then re-fastened the step with the two bolts. So far so good. On my next attempt at raising the mast, a friend helped. He raised the mast to head height standing on the fore deck while I hauled. Then grabbed the boom to keep it steady. At which point the same damn thing happened for the same damn reason - I forgot to attach the roller furled to the mast and raise them both together, instead it was trailing off the bow. Monumental, sweaty, end-of-day idiocy. Friend is holding the boom stable, roller furled gets stuck, he goes to unstick, boom wavers uncontrollably, mast and boom land on deck. Fortunately the step itself wasn't bent a second time. But I was now traumatized. So I drilled through the deck and this time fixed the step in place with (3 inch?) ss through bolts, washers, and lock nuts. Lesson learned: the pressure on the step fittings from zero degrees up to 45 degrees with this method is tremendous. Once the mast reaches 45 degrees the pressure lessens and continues to lessen up to 90 degrees. I saw in the archives what looks like a brilliant contraption made from a pvc joint cut in half and then held in place with metal straps to hold the boom rigidly to the mast at 90 degrees. Has anyone else experience with this device? Ultimately I want to be able to raise the mast by myself, since I sail mostly solo. So there is my first confession. I'd love to read that I'm not alone… Jefferson SV Patience Lake Memphremagog, Quebec -- View this message in context: http://rhodes-22.1065344.n5.nabble.com/Your-favorite-way-of-pulling-out-mast-step-tp49974p50309.html Sent from the Rhodes 22 mailing list archive at Nabble.com.See the original archive post