The Rhodes 22 Discussion Group R22 Discussion Group

The Rhodes 22 Discussion Group


< prior

Back to Month

Go to Thread

Member Picture

The Rhodes 22 Email List



Lazarette Leak | to Cabin

2015-07-24; 20:03:17 EDT

Member Since

2014-05-06

Posts: 3821

Graham,

I miss spoke here, I actually added some fiberglass to the floor of the
lazarette, mostly near the wall that is formed by the aft side of the
flotation foam.  In my case, there was delaminated tabbing at the junction
of the hull and flotation foam. I removed the bad tabbing,  ground the hull
surface, cleaned and then glassed an area along the entire foam wall
extending toward the stern perhaps 10 ". No mods were made to the transom.

I added extra biaxial because when I was stepping around in the lazarette to
find the leaks there, I noticed that the hull (lazarette floor) seemed to
give a lot.  My boat was built in 1978. The hull is solid woven roving and
mat. Following adding the extra glass, the lazarette definitely gives less.

At the time I thought that I would modify the boat  lift to support the boat
from the bow and the stern, but I now don't think I will do it this way.  

Regards,

Gary
S/V Moon Shadoww
Fort Pierce FL

See the original archive post
×

Message to Webmaster:

To use your email application to send a messsage to the webmaster rather than this form, .



×

Post to the Rhodes 22 Email List:



×

Sending Post:

Your post is being sent... waiting