The Rhodes 22 Discussion Group R22 Discussion Group

The Rhodes 22 Discussion Group


< prior

Back to Month

Go to Thread

Member Picture

The Rhodes 22 Email List



Lazarette Leak | to Cabin

2015-07-24; 22:38:24 EDT

Member Since

2014-05-06

Posts: 3821

Graham,

By the time I bought my boat, any trace of a wood partition was long gone.
Of course, there must have been one because the aft wall of the flotation
foam is very smooth.  I (I should say we) managed to get the new glass
nearly all the way to the top of the foam. I say we,  because as the project
drug on that day I had my wife help me with the glassing of the foam wall.
I laid the floor part and then she crawled in and did the wall. The foam was
soaked with laminating epoxy first and then 3 layers of mat/ biaxial were
laid down in rapid sequence. She did a great job, only a few air pockets
appeared underneath the first layer on the wall so I was very happy with the
adherence. The finished product looks good and is waterproof at least till
the water reaches near the top of the wall.

While on the hard the lazarette water intrusion was a constant problem.
There are a lot of trees in my yard and stuff was constantly clogging the
drains even after they were enlarged. One day after a particularly heavy
overnight rain, I woke up to discover the boat trailer with the tongue
hanging up in the air.  The now waterproof lazarette filled up with water
sifting the center of gravity way towards the stern. Fortunately the boat
was well tied to the trailer and did not slip off. 

As a later project, I installed a bilge pump in the lazarette which is on a
manual switch (no float) but I never have to use it since the boat drains
work fine now that it is on the boat lift. 

I  also added extra glass to my boat in the following locations 

1. Bilge all around the stringers and up to and including the centerboard
trunk, actually this means all glass seen when the sole is removed. All
traces of delamination ground out and laid 3-4 layers of biaxial. (4 layers
near centerboard trunk)

2. The center board trunk cap completely covered in 3 layers of biaxial

3. the fiberglass cap over the top of the forward ballast. 4 layers of
biaxial. The mast indirectly rests on this. Additional wood work was also
performed here, fiberglass work was only part of this project.

All I can say is the fiberglass centerboard trunk cap seemed quite weak when
I initially removed it. After the glass work I can stand on it and it feels
rock hard.

Regards,

Gary

See the original archive post
×

Message to Webmaster:

To use your email application to send a messsage to the webmaster rather than this form, .



×

Post to the Rhodes 22 Email List:



×

Sending Post:

Your post is being sent... waiting