< prior
Back to Month
Go to Thread
2015-07-24; 23:59:41 EDT
Member Since
2014-05-06
Posts: 3821
Very impressive. Do you think I might borrow your wife for a day? GrahamSee the original archive post
-----Original Message----- From: rhodes22-list-bounces at rhodes22.org [mailto:rhodes22-list-bounces at rhodes22.org] On Behalf Of The Rhodes 22 Email List Sent: July 24, 2015 10:38 PM To: 'The Rhodes 22 Email List' Subject: Re: [Rhodes22-list] Lazarette Leak | to Cabin Graham, By the time I bought my boat, any trace of a wood partition was long gone. Of course, there must have been one because the aft wall of the flotation foam is very smooth. I (I should say we) managed to get the new glass nearly all the way to the top of the foam. I say we, because as the project drug on that day I had my wife help me with the glassing of the foam wall. I laid the floor part and then she crawled in and did the wall. The foam was soaked with laminating epoxy first and then 3 layers of mat/ biaxial were laid down in rapid sequence. She did a great job, only a few air pockets appeared underneath the first layer on the wall so I was very happy with the adherence. The finished product looks good and is waterproof at least till the water reaches near the top of the wall. While on the hard the lazarette water intrusion was a constant problem. There are a lot of trees in my yard and stuff was constantly clogging the drains even after they were enlarged. One day after a particularly heavy overnight rain, I woke up to discover the boat trailer with the tongue hanging up in the air. The now waterproof lazarette filled up with water sifting the center of gravity way towards the stern. Fortunately the boat was well tied to the trailer and did not slip off. As a later project, I installed a bilge pump in the lazarette which is on a manual switch (no float) but I never have to use it since the boat drains work fine now that it is on the boat lift. I also added extra glass to my boat in the following locations 1. Bilge all around the stringers and up to and including the centerboard trunk, actually this means all glass seen when the sole is removed. All traces of delamination ground out and laid 3-4 layers of biaxial. (4 layers near centerboard trunk) 2. The center board trunk cap completely covered in 3 layers of biaxial 3. the fiberglass cap over the top of the forward ballast. 4 layers of biaxial. The mast indirectly rests on this. Additional wood work was also performed here, fiberglass work was only part of this project. All I can say is the fiberglass centerboard trunk cap seemed quite weak when I initially removed it. After the glass work I can stand on it and it feels rock hard. Regards, Gary -----Original Message----- From: rhodes22-list-bounces at rhodes22.org [mailto:rhodes22-list-bounces at rhodes22.org] On Behalf Of The Rhodes 22 Email List Sent: Friday, July 24, 2015 9:26 PM To: 'The Rhodes 22 Email List' <rhodes22-list at rhodes22.org> Subject: Re: [Rhodes22-list] Lazarette Leak | to Cabin Thanks Gary: The plywood wall between the foam and the lazarette is rotted out in my boat too. The plywood was very thin - no more the 1/4" leading me to think that it was intended only as a barrier when the foam was poured rather than have any structural purpose. I tried to glass over the foam but made an awful job of the glass and ended up removing it before it set. Somehow, hanging upside down into the lazarette while trying to glass a vertical surface was too much for me so I just coated the foam with epoxy to seal it off and will let any water drain into the bilge. I haven't had a problem with water in the lazarette since I replaced the 3/4" mushroom thru-hulls with 1 1/2" flush mounted scabbards. I have been thinking about reinforcing the hull throughout the boat below the waterline with a few layers of cloth. The hull seems very flexible to me and has been damaged where the front trailer struts support the hull. Problem is I don't really know how many layers of cloth would significantly strengthen the hull. How many layers did you use in the lazarette? Graham Stewart Agile. R22, 1976 Kingston Ontario Canada -----Original Message----- From: rhodes22-list-bounces at rhodes22.org [mailto:rhodes22-list-bounces at rhodes22.org] On Behalf Of The Rhodes 22 Email List Sent: July 24, 2015 8:03 PM To: 'The Rhodes 22 Email List' Subject: Re: [Rhodes22-list] Lazarette Leak | to Cabin Graham, I miss spoke here, I actually added some fiberglass to the floor of the lazarette, mostly near the wall that is formed by the aft side of the flotation foam. In my case, there was delaminated tabbing at the junction of the hull and flotation foam. I removed the bad tabbing, ground the hull surface, cleaned and then glassed an area along the entire foam wall extending toward the stern perhaps 10 ". No mods were made to the transom. I added extra biaxial because when I was stepping around in the lazarette to find the leaks there, I noticed that the hull (lazarette floor) seemed to give a lot. My boat was built in 1978. The hull is solid woven roving and mat. Following adding the extra glass, the lazarette definitely gives less. At the time I thought that I would modify the boat lift to support the boat from the bow and the stern, but I now don't think I will do it this way. Regards, Gary S/V Moon Shadoww Fort Pierce FL -----Original Message----- From: rhodes22-list-bounces at rhodes22.org [mailto:rhodes22-list-bounces at rhodes22.org] On Behalf Of The Rhodes 22 Email List Sent: Friday, July 24, 2015 6:32 PM To: 'The Rhodes 22 Email List' <rhodes22-list at rhodes22.org> Subject: Re: [Rhodes22-list] Lazarette Leak | to Cabin Gary: I am wondering why you "added additional layers of fiberglass to the hull in the transom"? Graham Stewart Agile. R22, 1976 Kingston Ontario Canada -----Original Message----- From: rhodes22-list-bounces at rhodes22.org [mailto:rhodes22-list-bounces at rhodes22.org] On Behalf Of The Rhodes 22 Email List Sent: July 24, 2015 12:26 PM To: 'The Rhodes 22 Email List' Subject: Re: [Rhodes22-list] Lazarette Leak | to Cabin Bob, My Rhodes had a similar problem especially when on the hard. I didn't want the water to get inside the boat by flowing thru and around the foam. Foam can begin to absorb water if its continuously exposed to it. This is an all too common problem with older power boats in Florida where I live. Google "waterlogged boat foam". I can't say for sure if this would happen to you or not, but it definitely started to happen on my boat. Before I discovered the problem was mostly the lazarette, I pulled the table mount base out of the cockpit. The last installer didn't caulk the base and water was indeed getting in there. The foam near the Hole was soaked and mushy. I dug out the bad and caulked/reinstalled the base after letting the remaining mostly dry crunchy foam dry out. I replaced my boat drains and hoses with larger ones and glassed over the foam up as much as I could, also added additional layers of fiberglass to the hull in the transom while I was at it. I added a bilge pump to the lazarrete to pump out any water that still gets in. . Now that the boats is on my lift I don't generally see more than a cup or so of water in the lazarette, as I don't get leaves on the boat now, only bird poop. Regards, Gary S/V Moon Shadoww Fort Pierce FL -----Original Message----- From: rhodes22-list-bounces at rhodes22.org [mailto:rhodes22-list-bounces at rhodes22.org] On Behalf Of The Rhodes 22 Email List Sent: Friday, July 24, 2015 8:06 AM To: The Rhodes 22 Email List <rhodes22-list at rhodes22.org> Subject: Re: [Rhodes22-list] Lazarette Leak | to Cabin Thank you all for the helpful replies. I intend to caulk for the rest of the 2015 sailing season. While standing on my head in the lazarette I noticed the lack of fiberglass? Same port side where leak was found. The lack of fiberglass is at the top, port side of forward, lazarette wall. Starboard side bulkhead is fully covered in fiberglass? Bob -----Original Message----- From: rhodes22-list-bounces at rhodes22.org [mailto:rhodes22-list-bounces at rhodes22.org] On Behalf Of The Rhodes 22 Email List Sent: Wednesday, July 22, 2015 9:40 PM To: The Rhodes 22 Email List <rhodes22-list at rhodes22.org> Subject: Re: [Rhodes22-list] Lazarette Leak | to Cabin Bob, I have found the brushes sold for cleaning the lint from clothes dryers ( long slender cone shaped) work great to keep the cockpit drains clean. I keep one on the boat. Cheap and easy! Just my thought. I hate re inventing the wheel. Cary S/V Whisper Radford, VA On Wed, Jul 22, 2015 at 5:37 PM, The Rhodes 22 Email List < rhodes22-list at rhodes22.org> wrote: > Bob, > On my 88 model the lazzerette is water tight. I would recommend > sealing it with either fiberglass or using a good caulk. > > Rummy > > > In a message dated 7/22/2015 11:48:08 A.M. Eastern Daylight Time, > rhodes22-list at rhodes22.org writes: > > Hello all, > > Repair help requested please? > > Our families '84 R22 is currently on its trailer (in our driveway). > During a recent rain storm, the P/S bench drains became clogged with > leaves and the water overflowed into the lazarette. The water was > high enough in the lazarette to move forward and soak the carpet in > the cabin. I bailed her out to find I'm lacking water tight integrity > at a point on port side in the lazarettes bulkhead. I can watch the > water drain, fwd to aft, thru the port side bulkhead, at the base of > the lazarette? > What's recommended by the list? Fiberglass repair? Puddy repair? Other? > > Thanks in advance, > Bob > Sunapee, NH > __________________________________________________ > To subscribe/unsubscribe go to > http://www.rhodes22.org/mailman/listinfo/rhodes22-list > > For the list Charter and help with using the mailing list and > archives go to http://www.rhodes22.org/list > __________________________________________________ > > __________________________________________________ > To subscribe/unsubscribe go to > http://www.rhodes22.org/mailman/listinfo/rhodes22-list > > For the list Charter and help with using the mailing list and archives > go to http://www.rhodes22.org/list > __________________________________________________ > __________________________________________________ To subscribe/unsubscribe go to http://www.rhodes22.org/mailman/listinfo/rhodes22-list For the list Charter and help with using the mailing list and archives go to http://www.rhodes22.org/list __________________________________________________ __________________________________________________ To subscribe/unsubscribe go to http://www.rhodes22.org/mailman/listinfo/rhodes22-list For the list Charter and help with using the mailing list and archives go to http://www.rhodes22.org/list __________________________________________________ __________________________________________________ To subscribe/unsubscribe go to http://www.rhodes22.org/mailman/listinfo/rhodes22-list For the list Charter and help with using the mailing list and archives go to http://www.rhodes22.org/list __________________________________________________ __________________________________________________ To subscribe/unsubscribe go to http://www.rhodes22.org/mailman/listinfo/rhodes22-list For the list Charter and help with using the mailing list and archives go to http://www.rhodes22.org/list __________________________________________________ __________________________________________________ To subscribe/unsubscribe go to http://www.rhodes22.org/mailman/listinfo/rhodes22-list For the list Charter and help with using the mailing list and archives go to http://www.rhodes22.org/list __________________________________________________ __________________________________________________ To subscribe/unsubscribe go to http://www.rhodes22.org/mailman/listinfo/rhodes22-list For the list Charter and help with using the mailing list and archives go to http://www.rhodes22.org/list __________________________________________________ __________________________________________________ To subscribe/unsubscribe go to http://www.rhodes22.org/mailman/listinfo/rhodes22-list For the list Charter and help with using the mailing list and archives go to http://www.rhodes22.org/list __________________________________________________
To use your email application to send a messsage to the webmaster rather than this form, .
Your post is being sent... 