The Rhodes 22 Discussion Group R22 Discussion Group

The Rhodes 22 Discussion Group


< prior

Back to Month

Go to Thread

Member Picture

The Rhodes 22 Email List



Trailer bearing question.

2015-08-15; 16:55:21 EDT

Member Since

2014-05-06

Posts: 3821

All the other advise is spot on,but if you have trouble getting the outer
races out of the hub ,take it to a welder and have him run a bean around
the center of the bearing. When it cool the race will shrink and should
fall out
  The best tip I've heard for taking care of boat trailer bearings is to
grease the bearing buddies after you get to the lake ,just before you
splash it.  The thinking is that th bearings heat up on the trip to the
lake,when the hot bearings hit the cool water,the grease and air in the
bearing shrink and create a vacuum,sucking in water and the grease and
junk that oozed out of the bearing on the way to the lake right in to
the bearing,just waiting to ruin your trip home. If you grease the
bearing before just before splash,there is no room for any thing to be
drawn in.

Jerry Lowe




am about to do an overhaul on my 27 year old Trailmaster Rhodes 22
See the original archive post
×

Message to Webmaster:

To use your email application to send a messsage to the webmaster rather than this form, .



×

Post to the Rhodes 22 Email List:



×

Sending Post:

Your post is being sent... waiting