< prior
Back to Month
Go to Thread
2015-09-01; 22:17:56 EDT
Member Since
2014-05-06
Posts: 3821
Brad-point drill bit , I meant to say. Cheers, TedSee the original archive post
> On Sep 1, 2015, at 10:15 PM, The Rhodes 22 Email List <rhodes22-list at rhodes22.org> wrote: > > Shit, too late, I filled them with epoxy today. I'll give her a go tomorrow with a fresh sharp drill bit. Wish me luck. > > Ted > >> On Sep 1, 2015, at 3:24 PM, The Rhodes 22 Email List <rhodes22-list at rhodes22.org> wrote: >> >> Ted: >> That is exactly what I am planning to do with two minor exceptions: 1, don't >> wait for the epoxy to cure completely before you drill the hole out. I did >> that once and found that the epoxy is much harder than the surrounding >> material and it was impossible to keep the drill bit centered. Wait for it >> to solidify (firm and not sticky) and drill the holes then. 2, Bbevel the >> holes to avoid cracks in the gel coat - here is a great article on bedding >> hardware with butyl - >> http://forums.sbo.sailboatowners.com/showthread.php?p=705346 . >> Graham >> >> -----Original Message----- >> From: rhodes22-list-bounces at rhodes22.org >> [mailto:rhodes22-list-bounces at rhodes22.org] On Behalf Of The Rhodes 22 Email >> List >> Sent: August 31, 2015 2:30 PM >> To: The Rhodes 22 Email List >> Subject: Re: [Rhodes22-list] Green goop with leaks >> >> Graham, >> >> I was hoping you were going to comment on my situation. Yes, I am only >> filling the holes with epoxy. I will rebed with butyl tape since I will >> eventually have nice new round (properly sized) hole with which to bed the >> railing. I am drilling a slightly oversized 5/8 inch hole. Then I will use a >> dremel tool to take out a very small section of the core around the hole. >> Next, I will close up the bottom of the hole with some duct tape and fill >> with west systems epoxy. After a few days, I plan to redrill and countersink >> 3/8 hole and use butyl tape to rebed the railing. >> >> Chers, >> Ted >> >> >>> On Aug 31, 2015, at 11:03 AM, The Rhodes 22 Email List >> <rhodes22-list at rhodes22.org> wrote: >>> >>> Ted: >>> I am not sure you intend to bed the bow rail to the deck with epoxy >>> but I would not do that. Definitely the plan to remove some core >>> material in the holes and filling that with epoxy is critical to avoid >>> core rot - assuming your deck is cored with plywood. At some point >>> Stan changed from plywood to foam core but I don't know when. For >>> bedding I would use sealant (3M 4200 or equivalent - not 5200) or >>> butyl tape. I will be using butyl tape myself as it seals beautifully, >>> never hardens and is easy to remove as it has virtually no adhesive >> qualities. >>> >>> >>> Graham Stewart >>> Agile. R22, 1976 >>> Kingston Ontario Canada >>> >>> >>> >>> -----Original Message----- >>> From: rhodes22-list-bounces at rhodes22.org >>> [mailto:rhodes22-list-bounces at rhodes22.org] On Behalf Of The Rhodes 22 >>> Email List >>> Sent: August 30, 2015 3:21 PM >>> To: Da List >>> Subject: [Rhodes22-list] Green goop with leaks >>> >>> Hey guys, looks like I may have the dreaded deck to hull joint leaks >>> on my recycled 1991/2013. I also have slight leaks at the bow pulpit >>> through bolts. It's leaking green goopy sealant along the port side. I >>> can see it on the white/gray carpet on the side of the port hull. I >>> took off the bow railing and plan to rebed the through bolts using >>> west systems epoxy. I started to clean out the existing holes by re >>> drilling slightly larger holes and used a dremel tool remove some of >>> the core material. I feel pretty good about the repair as there are >>> lots of demonstrations on You Tube and various boating web sites. >>> >>> What is the best way to remove the rub rail to inspect the deck to >>> hull joint? >>> >>> Cheers, >>> Ted >>> >>> s/v AIRPOWER >>> Jacksonville, FL >>> 1991/2013 Rhodes 22 >>> >>> >>> >>> __________________________________________________ >>> To subscribe/unsubscribe go to >>> http://www.rhodes22.org/mailman/listinfo/rhodes22-list >>> >>> For the list Charter and help with using the mailing list and archives >>> go to http://www.rhodes22.org/list >>> __________________________________________________ >>> >>> __________________________________________________ >>> To subscribe/unsubscribe go to >>> http://www.rhodes22.org/mailman/listinfo/rhodes22-list >>> >>> For the list Charter and help with using the mailing list and archives >>> go to http://www.rhodes22.org/list >>> __________________________________________________ >> >> >> __________________________________________________ >> To subscribe/unsubscribe go to >> http://www.rhodes22.org/mailman/listinfo/rhodes22-list >> >> For the list Charter and help with using the mailing list and archives go to >> http://www.rhodes22.org/list >> __________________________________________________ >> >> __________________________________________________ >> To subscribe/unsubscribe go to http://www.rhodes22.org/mailman/listinfo/rhodes22-list >> >> For the list Charter and help with using the mailing list and archives go to http://www.rhodes22.org/list >> __________________________________________________ > > __________________________________________________ > To subscribe/unsubscribe go to http://www.rhodes22.org/mailman/listinfo/rhodes22-list > > For the list Charter and help with using the mailing list and archives go to http://www.rhodes22.org/list > __________________________________________________
To use your email application to send a messsage to the webmaster rather than this form, .
Your post is being sent... 