The Rhodes 22 Discussion Group R22 Discussion Group

The Rhodes 22 Discussion Group


< prior

Back to Month

Go to Thread

Member Picture

The Rhodes 22 Email List



Bilge ventilation

2015-09-12; 11:10:32 EDT

Member Since

2014-05-06

Posts: 3821

Bob:

Best and crucial solution is to stop the leaks. I have gone to ridiculous
lengths to do that by glassing the hull-heck joint and installing full
acrylic window coverings to replace all ports.

I am not sure that ventilation alone would preclude rot over time if the
bilge is not dry otherwise. I plan to rebuild the floor and stringers with
rot resistant materials - I will probably use pressure treated pine for the
structural pieces. That said, ventilation still serves a purpose in terms of
mold and mildew etc. 

I have installed a solar vent that should keep air moving in the boat. The
bilge is hardly air tight at the best of time and, so long as water is not
getting in, good cabin ventilation should be sufficient to move air through
the bilge. For long periods and during the winter when the solar vent may
not be operating I will leave the floor access panels open. 



Graham Stewart
Agile. R22, 1976
Kingston Ontario Canada




See the original archive post
×

Message to Webmaster:

To use your email application to send a messsage to the webmaster rather than this form, .



×

Post to the Rhodes 22 Email List:



×

Sending Post:

Your post is being sent... waiting