The Rhodes 22 Discussion Group R22 Discussion Group

The Rhodes 22 Discussion Group


< prior

Back to Month

Go to Thread

Member Picture

The Rhodes 22 Email List



Table base location

2015-09-14; 12:32:22 EDT

Member Since

2014-05-06

Posts: 3821

I purchased one from Walmart and cut it to length then used a plumbers
crimping tool to taper the cut end to fit into the base. Before I started
using this I ripped the screws out on the end battens a couple of times and
ended up through-bolting with giant washers to spread the load. Maybe I
should lose some weight!

See the original archive post
×

Message to Webmaster:

To use your email application to send a messsage to the webmaster rather than this form, .



×

Post to the Rhodes 22 Email List:



×

Sending Post:

Your post is being sent... waiting