< prior
Back to Month
Go to Thread
2015-09-28; 21:28:16 EDT
Member Since
2014-05-06
Posts: 3821
Graham: Wow! Very nice work. Stan would be proud of your work. {:>)
Bob "NoKaOi 3"
On Sunday, September 27, 2015 7:11 PM, The Rhodes 22 Email List <rhodes22-list at rhodes22.org> wrote:
I like the off white color.
Cheers,
Ted
S/V AIRPOWER
1991/2013 R22
Jacksonville, FL
See the original archive post
> On Sep 27, 2015, at 6:14 PM, The Rhodes 22 Email List <rhodes22-list at rhodes22.org> wrote: > > I applied the nonskid to the cockpit yesterday. I put the Kiwigrip on the > cockpit sole, seats and coaming tops. It hides imperfections nicely. > Pictures are attached. Next I will do the lazarette cover and poptop. > > Graham Stewart > Agile. R22, 1976 > Kingston Ontario Canada > > > > > -----Original Message----- > From: rhodes22-list-bounces at rhodes22.org > [mailto:rhodes22-list-bounces at rhodes22.org] On Behalf Of The Rhodes 22 Email > List > Sent: September 26, 2015 10:07 AM > To: The Rhodes 22 Email List > Subject: Re: [Rhodes22-list] Non-skid > > Nice job Graham,and an excellent write up,too boot. Please don't stop > writing about your rebuild,it may not mean much to most of us now,but future > owners and down the road for a lot of us will really benefit from your > willingness to share your experiences. I know I really benefited from > another rhodies post on rebuilding the compression post support stringers. > It turned out better than if I would have entered the project blindly. > Your not guilty f this,but I and many others are,so this is a shout out to > everyone,MAKE SURE the subject line on the list describes the actual subject > or all your work will get lost in the archives > > Thanks, > Jerry Lowe > > > > > > > We had fabulous weather for Ontario in September this week and I was able >> to mask the boat and apply non-skid. I have done the cabin top, side >> decks and foredeck. The cockpit and pop top still need to be done - >> hopefully tomorrow -but you can see the effect for the attached photos. >> >> The biggest part of the job by far was the masking and in particular >> rounding the corners. I used a 3/4 in washer as a template for the >> corners. They looked great with the blue masking tape but with the >> non-skid being rough and a similar color to the deck paint the profile >> of the corners virtually disappeared. So my advice would be to >> exaggerate the rounded corners if you want them to be very visible. I >> was amazingly lucky color wise. The deck paint and the non-skid are >> both off-white and from different manufacturers, both of whom have >> very limited choice, but as it turned out the two coatings go together > very well. >> >> >> I used Kiwigrip for the non-skid because of what I had read about it >> being very durable and easy to apply. I will have to wait to see how >> durable it is but can attest to it being easy to apply. Once the >> surface is prepared you apply the thick paint with a 1/8" notched >> trowel to get an even but thick layer and then roll it out with a >> special roller sold by the manufacturer. The harder you press the more >> aggressive the non-skid. I found I had to press firmly to get rid of >> the lines from the trowel but then lightened up in an attempt to tame >> it a bit. The non-skid is still much more aggressive than the original >> pattern molded into the Rhodes deck but the surface is not particularly > sharp. >> >> It is a latex paint so it dries to the touch in a few hours. You pick >> up the technique for rolling the non-skid in a matter of minutes. I >> practiced for a few minutes on a piece of cardboard. This product is >> not cheap but I think it is worth it from an effort point of view. >> >> Because it dries quickly you have to apply it in small sections. They >> recommend sections between 2 and 4 sq. ft. and so you need to carve up >> the deck into manageable pieces. You also need to remove the masking >> tape as you go - one section at a time before you move on to the next. >> As a result the process is pretty messy and so I was glad I used >> extensive masking . I could not remove the tape wearing gloves so my >> hands were covered in paint. Fortunately is washes off pretty easily >> with water. Tool cleanup is also easy. >> >> Based on this experience I don't think I would consider anything else >> as it is hard to see how it could be easier and still give a nice >> looking result. >> >> They recommend that this be done by two people but I didn't have that >> option available to me and managed fine on my own. I bought one gallon >> of the paint and that will be more than enough to use the non skid >> paint extensively on the cabin top, pop top, cockpit seats and >> probably coaming tops as well as all of the original non-skid. If you >> were only doing the original non-skid areas two quarts would be > sufficient. >> >> I suppose I should mention why all of this was necessary given that >> the Rhodes has a very nice pattern moulded into the deck. I had to do >> major surgery on my foredeck to replace the core. It involved cutting >> the deck in half and removing it from the boat. Reinstalling it meant >> there was a major scar across the deck that destroyed the non-skid >> pattern. I also wanted to strengthen the deck a bit so I glassed over >> the entire non-skid area. Now that I thnk about it all of the >> foregoing is probably of little value to those on this list. >> >> >> Graham Stewart >> Agile. R22, 1976 >> Kingston Ontario Canada >> >> >> __ >> -------------- next part -------------- A non-text attachment was >> scrubbed... >> Name: Non-skid masking Sept 2015.jpg >> Type: image/jpeg >> Size: 417912 bytes >> Desc: not available >> Url : >> http://www.rhodes22.org/pipermail/rhodes22-list/attachments/20150925/4 >> 138d6a8/attachment.jpg >> -------------- next part -------------- A non-text attachment was >> scrubbed... >> Name: Non-skid port side September 2015.jpg >> Type: image/jpeg >> Size: 368773 bytes >> Desc: not available >> Url : >> http://www.rhodes22.org/pipermail/rhodes22-list/attachments/20150925/4 >> 138d6a8/attachment-0001.jpg >> __________________________________________________ >> To subscribe/unsubscribe go to >> http://www.rhodes22.org/mailman/listinfo/rhodes22-list >> >> For the list Charter and help with using the mailing list and archives >> go to http://www.rhodes22.org/list >> __________________________________________________ > > > __________________________________________________ > To subscribe/unsubscribe go to > http://www.rhodes22.org/mailman/listinfo/rhodes22-list > > For the list Charter and help with using the mailing list and archives go to > http://www.rhodes22.org/list > __________________________________________________ > -------------- next part -------------- > A non-text attachment was scrubbed... > Name: Nonskid in cockpit September 2015.jpg > Type: image/jpeg > Size: 430372 bytes > Desc: not available > Url : http://www.rhodes22.org/pipermail/rhodes22-list/attachments/20150927/6c9cd236/attachment.jpg > -------------- next part -------------- > A non-text attachment was scrubbed... > Name: nonskid on cockpit sole September 2015.jpg > Type: image/jpeg > Size: 490026 bytes > Desc: not available > Url : http://www.rhodes22.org/pipermail/rhodes22-list/attachments/20150927/6c9cd236/attachment-0001.jpg > __________________________________________________ > To subscribe/unsubscribe go to http://www.rhodes22.org/mailman/listinfo/rhodes22-list > > For the list Charter and help with using the mailing list and archives go to http://www.rhodes22.org/list > __________________________________________________ __________________________________________________ To subscribe/unsubscribe go to http://www.rhodes22.org/mailman/listinfo/rhodes22-list For the list Charter and help with using the mailing list and archives go to http://www.rhodes22.org/list __________________________________________________
To use your email application to send a messsage to the webmaster rather than this form, .
Your post is being sent... 