2015-10-14; 15:39:53 EDT
Member Since
2014-05-06
Posts: 3821
I had the same problem Lynn, and wound up replacing the pin with one from Zoro that looked like this - https://www.zoro.com/search?q=plunger+pin Part of the problem was that the pin was only supported laterally by the plastic of the slide (not by a metal sleeve), and part was that it wasn't long enough. In addition, the hole in the mast was a bit too large for my liking, but I could have lived with that if the pin was beefy enough. The new pin looks like https://www.zoro.com/innovative-components-plunger-pin-ring-063-in-38-16-028-3jcy9/i/G0305541/ - one of the pieces from the "plunger pin" search above. I had to drill & tap the plastic to accommodate the new pin, but once the boom iss locked in place now, it's there for the duration - no more falling! I won't have access to the boat until the middle of December, so can't take pix or measure it - but the above should point you in the right direction - or at least the direction I took! Dennis Magic Moments Takin' a break & heading south :)See the original archive post