On Thu, Oct 15, 2015 at 6:55 PM, The Rhodes 22 Email List <
rhodes22-list at rhodes22.org> wrote:
> Whatever you use to cut the fibreglass you will still need to grind a bevel
> edge to accept layers of fibreglass to mend the cut. I would be inclined to
> cut out the sole 4 inches in from the edge and replace the nonskid pattern
> with non-skid paint once it is reinstalled. That would be easiest. You
> should be able to cut with a circular saw with the blade installed
> backwards. You can set the depth to ensure that you don't cut too deep.
>> Graham Stewart
> Agile. R22, 1976
> Kingston Ontario Canada
>>>> -----Original Message-----
> From: rhodes22-list-bounces at rhodes22.org> [mailto:rhodes22-list-bounces at rhodes22.org] On Behalf Of The Rhodes 22
> Email
> List
> Sent: October 15, 2015 4:49 PM
> To: rhodes22-list at rhodes22.org> Subject: Re: [Rhodes22-list] spongy cockpit sole
>> Maybe I'll drill a small hole on the side to see what I run into - plywood
> or foam. Also it will allow to drain off the water in there. What saw would
> work well for getting a nice straight cut on the fiberglass?
>>>> -----
> Fair winds and following seas ..... Steve Raye
> --
> View this message in context:
>>http://rhodes-22.1065344.n5.nabble.com/spongy-cockpit-sole-tp51110p51116.htm> l
> Sent from the Rhodes 22 mailing list archive at Nabble.com.
> __________________________________________________
> To subscribe/unsubscribe go to
>http://www.rhodes22.org/mailman/listinfo/rhodes22-list>> For the list Charter and help with using the mailing list and archives go
> to
>http://www.rhodes22.org/list> __________________________________________________
>> __________________________________________________
> To subscribe/unsubscribe go to
>http://www.rhodes22.org/mailman/listinfo/rhodes22-list>> For the list Charter and help with using the mailing list and archives go
> to http://www.rhodes22.org/list> __________________________________________________
>
×
Message to Webmaster:
To use your email application to send a messsage to the webmaster rather than this form,
.