2015-10-24; 17:52:08 EDT
Member Since
2014-05-06
Posts: 3821
Ted: I think all sailboats behave differently on port and starboard tacks. Certainly mine does. Uneven weight distribution in the boat, which is always the case, will influence the amount of heel and that alone has an impact. Variations in the shape of the hull, slight misalignment of the centreboard etc. etc. etc. are all possible reasons. If the difference really bothers you, start with the rig and in particular make sure the mast is actually vertical by making sure that both top stays are the same length when under tension. Do that before putting tension on the lower stays which should be tightened only as needed to straighten the mast once it is perfectly vertical. You can tell when the mast is straight by looking up the sail track. You might find that you have to go back and forth a few times in an iterative process to get the mast both vertical and straight - side to side. You can attach the tip of a measuring tape or non-stretch line to a halyard and take it to the top of the mast and then measure to the chain plate on both sides. It is quite possible to have the correct tension on both sides while one stay, when tensioned, is longer than the other. If you have a standard rig there should only be a very slight rake. Too much or too little will result in either weather or lee helm. If that is the case now, I would suspect that some aspect of the rig tuning is the villain and all of the other suggestions given by others are good places to look. Graham Stewart Agile. R22, 1976 Kingston Ontario CanadaSee the original archive post