2016-04-28; 10:27:36 EDT
Member Since
2003-10-12
Posts: 163
Graham, I read most of your response regarding your CB trunk repair. Roger originally recommended the Garolite because its properties offer superior durability and easy to glass in. THe job was VERY tricky to drop them in with bailing wire, check for any big spaces then epoxy them in. As I recall some of the larger voids were so deep I used lathe wood to give me some surface area and back support with which I epoxied the G10. THen I still had to glass over the seams which was the hardest part as I recall. There was another chap from Baltimore area a few yrs back who had similar issues and just trowled in hydraulic cement incrementally. He then just epoxied over that cement and it did work also. Probably quicker and offered more ballast. To finish my job and add ballast I added a few gallons of sand poured in by drilling holes in my bilge next to the slot where I knew the voids resided. I added a few small batches of epoxy also. I liked your idea of making the plywood template of the center part of the board where the pivot slot operates. Good Idea BTW: I also had to remove my pivot slots by cutting them out VERY carefully, taking them home and adding more glass and epoxy before re glassing them back in. I took careful measurements and pictures to assist in replacing them. The entire job took over a season on land. I do remember I began cutting the trunk panels out when still on my trailer in the winter of 2004-05. The job finished around end of September 2005. Then I began working on the bilge and stringers which needed to be replaced due to water rot. How many months do you get in your part of Canada to sail? be well Lou -- View this message in context: http://rhodes-22.1065344.n5.nabble.com/Swing-keel-help-tp47899p51932.html Sent from the Rhodes 22 mailing list archive at Nabble.com.See the original archive post