The Rhodes 22 Discussion Group R22 Discussion Group

The Rhodes 22 Discussion Group


< prior

Back to Month

Go to Thread

Member Picture

Graham Stewart



Swing keel help

2016-04-28; 11:35:00 EDT

Member Since

2005-04-29

Posts: 816

Lou:

I admire your nerve in cutting out the pivot slots. I have undertaken a few
adventurous repairs but something so critical and also inaccessible might
defeat me. Getting those pieces back in their proper place, perfectly
aligned and rock solid would have me up nights for a long time and probably
break my back before it was done. Good for you.

I can't help but feel that filling the voids in the keel would in itself be
an essential preventative step whether it is sand and epoxy as you did or
polyester resin as I did. The fact that there were such large areas that
would attract water seems to be a disaster in waiting. I have no idea
whether the voids were there from the start of formed later. I suspect the
latter or perhaps both. Voids might explain why the cracks formed at the
bottom of my keel and why the sidewalls pushed in in your case. Once the
cracks form the water gets in easily and can do a lot of damage very quickly
especially when the fill is cement. I can only hope that my fix lasts as
well as yours.

My advice to anyone but especially those with older boats and those that
experience freezing temperatures is to get right under the keel and examine
it carefully for any cracks or distortions there or in the sidewalls. Tap
with a wooden handle in areas that raise any suspicion and listen for
telltale sound of a space below the surface. If there are any signs of
trouble, fix it now rather than wait until the repair is truly daunting.

Your postings with such detailed instructions have been enormously helpful.

Graham

See the original archive post
×

Message to Webmaster:

To use your email application to send a messsage to the webmaster rather than this form, .



×

Post to the Rhodes 22 Email List:



×

Sending Post:

Your post is being sent... waiting