> On Apr 29, 2016, at 3:50 PM, cjlowe at sssnet.com wrote:
>>>> If you use nuts to lock the turnbuckle, one of the nuts on each turnbuckle
> will have to have left handed threads. Meaning the nut turns counter
> clockwise to thread onto the bolt.
> I prefur to use cotter rings to lock the turnbuckles . Think key rings,
> only stainless steel and smaller.
> You probably know this,but unless Your getting pounded by big wind or
> wakes, you can remove any one turnbuckle at a time,safely.
>> Jerry
>>>> I’ve got a question about the turnbuckles on my six shrouds. Most of
>> male or bolt-like pieces have holes in the ends of them, which I assume
>> are intended to receive cotter pins or rings, which would keep the
>> turnbuckle from turning. But two of the bolts do not have holes in them.
>> In one case it’s lower bolt, in the other it’s the upper bolt, the one
>> attached to the wire.
>>>> I don’t think I could remedy the situation by drilling holes in the
>> bolts without them. I’m thinking I could thread nuts onto the bolts
>> above or below the body of the turnbuckle, and tighten them against the
>> body to keep it from moving.
>>>> Would this be an appropriate solution?
>>>> I hope my description of the problem is good enough that a picture isn’t
>> necessary, but I’ll attempt to attach one anyway, mostly as a test to
>> see if it works.
>>>> Thanks,
>>>> Peter Nyberg
>> Coventry, CT
>> s/v Silverheels (88/16)
>>>> __________________________________________________
>> To subscribe/unsubscribe go to
>>http://www.rhodes22.org/mailman/listinfo/rhodes22-list>>>> For the list Charter and help with using the mailing list and archives go
>> to http://www.rhodes22.org/list>> __________________________________________________
>>> __________________________________________________
> To subscribe/unsubscribe go to http://www.rhodes22.org/mailman/listinfo/rhodes22-list>> For the list Charter and help with using the mailing list and archives go to http://www.rhodes22.org/list> __________________________________________________
×
Message to Webmaster:
To use your email application to send a messsage to the webmaster rather than this form,
.