The Rhodes 22 Discussion Group R22 Discussion Group

The Rhodes 22 Discussion Group


< prior

Back to Month

Go to Thread

Member Picture

Ric Stott



hull-deck join fastening

2016-06-15; 13:57:34 EDT

Member Since

2013-07-01

Posts: 438

HI Graham
The aluminum rub rail was destroyed when the boat broke off its mooring last fall and landed against the rocks on the nearest beach. 
The aluminum rail was  corroded and on the list for replacement anyway, but all that fiberglass work was not on the list. 
Repairs are complete and the boat will be launched as soon as I get a few parts for the motor - on back order. 
I have no worries about screws removing themselves, I hit each screw with a touch of silicone prior to installation and there are more than 100 of them, so if and when the hull separates from the deck, I’ll be separated from this lifetime. Screws are much easier. 
The rail you showed looks nice.  I like the two color one though. Stan has been using a different one with a red insert and black base.  It looks great and Stan has the insert but not the base.  By the time I bought things separately, it would have  cost $400, so I opted for the less expensive solution. It looks pretty good .  
Ric
 s/v Dadventure 
Hampton bays 





See the original archive post
×

Message to Webmaster:

To use your email application to send a messsage to the webmaster rather than this form, .



×

Post to the Rhodes 22 Email List:



×

Sending Post:

Your post is being sent... waiting