2016-06-16; 19:29:05 EDT
Member Since
2016-06-09
Posts: 24
My new/used 89 Rhodes22 came with a 5 year old Triad custom trailer. First, the simple question: Brakes are rusted and unusable without service, and I was told it is not worth trying to keep them working since the boat is launched in salt water. What do you think? Second: The trailer is the custom built Triad Rhodes 22 model. ei. no adjustments other than extending the v shaped bow cushion arm that the stem is snug into. When the boat was last loaded it appears to have been pulled up toop far on the trailer. First, the tongue weight appeared really heavy based on the effort needed to crank up the swivel wheel and the load when hitched to a large tow vehicle. Second, the forward end of the long bunks was denting the hull on both sides. I put a temporary cross piece in about 6 feet aft of the bow and jacked up several inches to take the load there in order to pop the dents back out. I have since launched the boat for the season but need to figure out how to set up the trailer better before reloading this fall. If I extend to v shaped cushion arm out all the way I can move the boat about 6-8" farther back on the trailer. That will help some, as the hull will be a little thinner and less weight will be forward of the bunks. But I don't think that will be enough. Plus, when I look at the trailer, I'm surprised that ALL the weight is on those two long bunks. There is nothing under the keel, nor under the bow section. I don't understand why it was done like that. Anybody with a Triad trailer that can help me? Talbot Rhodes22 89/08 "Remains Nameless" -- View this message in context: http://rhodes-22.1065344.n5.nabble.com/Triad-Trailer-brakes-and-adjustments-tp52121.html Sent from the Rhodes 22 mailing list archive at Nabble.com.See the original archive post