The Rhodes 22 Discussion Group R22 Discussion Group

The Rhodes 22 Discussion Group


< prior

Back to Month

Go to Thread

Member Picture

Rick Lange



Triad Trailer brakes and adjustments

2016-06-30; 13:16:30 EDT

Member Since

2008-12-25

Posts: 1035

I guess it is more accurate to say the "keel guides", as ML calls them,
support the keel box around the keel rather than the actual keel.  I always
pull the diamond board all the way up when trailering to preserve the
roller.

When I replaced my bunk boards that were rotting, Stan told me to be sure
the keel guides supported the weight of the boat.  This was done by letting
the boat stand a day or so on the newly repaired trailer allowing the
boards to deform as the boat settled onto the keel guides.  Slots, rather
than holes, on the Triad bunk braces allow this to happen.

That is, when new bunk boards are attached to the empty trailer, the bolt
holes are drilled into the boards at the outer ends of the slots.  Then the
bolts are only loosely tightened to hold the boards in place while the boat
is gently dropped onto the trailer.  After the boat has settled, the bolts
will be close to the inner ends of the slots and should be tightened.

Rick

See the original archive post
×

Message to Webmaster:

To use your email application to send a messsage to the webmaster rather than this form, .



×

Post to the Rhodes 22 Email List:



×

Sending Post:

Your post is being sent... waiting