2016-07-06; 12:46:19 EDT
Member Since
2005-04-29
Posts: 816
A while back there was some discussion about putting the navigation lights on the bow pulpit. I recently found a way to do that relatively cheaply using the hardware shown in the attached pictures. Installation does not require welding of a mount to the pulpit and allows for the light to be rotated down out of the way when the mast is resting on the pulpit. The wiring is fed through a hole in the rail and down through the foot of the bow rail into the cabin V birth. It might not be the sturdiest arrangement and only time will tell whether this arrangement is adequate. For those who have been aware of my endless restoration odyssey, you will be relieved to know that with the nav light and deck hardware now installed I have finally finished the rebuild of the keel, windows, deck delamination and exterior of the boat. Now for the interior... I think the end is within sight. Graham Stewart Agile. R22, 1976 Kingston Ontario Canada Bow light bracket for pulpit..jpg Bow light triangular bracket.jpg Bow navigation light installed July 5, 2016.jpg Exterior hardware installed July 5. 2016 (1).jpgSee the original archive post