The Rhodes 22 Discussion Group R22 Discussion Group

The Rhodes 22 Discussion Group


< prior

Back to Month

Go to Thread

Member Picture

Chris Geankoplis



Thinking Ahead

2016-08-12; 10:51:58 EDT

Member Since

2004-04-05

Posts: 2062

Hey Joe!
            No problem on the access to the centerboard cap.  Get a
cordless drill and remove the L-shaped portion of the settee top.  Takes
less than 5 minutes.
           Next, depending on configuration you will need to remove the
floor boards.  Again perhaps 20 minutes tops.  I've done this a number of
times and it doesn't take that much time.  Just remove the sections you
need in the center to access the cap.  If the cap is nuts and bolts it is
easy.  If it is rivets then you will need to drill them out and replace
with SS bolts, washers and nuts. This will give you access to the
centerboard and hardware from above while the boat is on the trailer.

Oh do this when the boat is out of the water. (grin)

Now if you are not inclined to do the above, several people (check
archives) got the boat off the trailer and on to stands so the centerboard
could be lowered all the way and then replaced the pennant and blocks and
any modifications to encourage the board to operate smoothly.  I've done it
both ways.  If you have a travel lift at your marina sometimes they will
let you hang it from one work day to the next and that is more than enough
time to do the job.  Good luck!

Chris Geankoplis
Enosis I

See the original archive post
×

Message to Webmaster:

To use your email application to send a messsage to the webmaster rather than this form, .



×

Post to the Rhodes 22 Email List:



×

Sending Post:

Your post is being sent... waiting