The Rhodes 22 Discussion Group R22 Discussion Group

The Rhodes 22 Discussion Group


< prior

Back to Month

Go to Thread

Member Picture

Goodness



deck shape

2016-08-20; 23:08:44 EDT

Member Since

2012-01-04

Posts: 260

Graham:  i assume that your mast has remained unstepped during your restoration. 
Remember you have an inner hull so your cabin top has two layers. The center of my cabin top interior dropped an inch immediately upon removing my compression post.  I had the floor bulkhead replaced within a week but had to lift the inner lining up to get the compression post to fit back into place.  It is nice and tight and the deck is level and firm.  Fiberglass is very flexible and strong. Make sure your base for the post is at the proper height however.  Do you have an original bulkehad as well?  That helps you guage that the compression post is in the right position.
Good luck!

Bob (palatka)

See the original archive post
×

Message to Webmaster:

To use your email application to send a messsage to the webmaster rather than this form, .



×

Post to the Rhodes 22 Email List:



×

Sending Post:

Your post is being sent... waiting