The Rhodes 22 Discussion Group R22 Discussion Group

The Rhodes 22 Discussion Group


< prior

Back to Month

Go to Thread

Member Picture

Graham Stewart



deck shape

2016-08-21; 09:08:25 EDT

Member Since

2005-04-29

Posts: 816

BoB:

 Thanks for the feedback. That is very helpful.
Yes, I had unstepped the mast and there was no load on the deck - not even
snow. I made the new bulkhead pieces using the old ones as templates and
placed them according to the fibreglass stubs that were in place to hold the
old pieces. Everything seems to be coming together properly so I am pretty
sure that the compression post base is in the correct place. The only
difference is that the old base had been distorting under the force of the
compression post over the years so the new piece corrected for that
accounting for perhaps as much as 1/2 inch in the drop of the cabin top.
What did you use to raise the cabin top in order to reinsert the compression
post? How much force did it take?
Thanks again,


Graham Stewart
Agile. R22, 1976
Kingston Ontario Canada




See the original archive post
×

Message to Webmaster:

To use your email application to send a messsage to the webmaster rather than this form, .



×

Post to the Rhodes 22 Email List:



×

Sending Post:

Your post is being sent... waiting