< prior
Back to Month
Go to Thread
2017-03-09; 06:37:50 EST
Member Since
2013-07-01
Posts: 438
Nice job Graham -very slick. Ric Dadventure HBNY Sent from my iPhoneSee the original archive post
> On Mar 8, 2017, at 9:02 PM, Graham Stewart <gstewart8 at cogeco.ca> wrote: > > Without signing your message we are unable to address you by name. > > I have attached a picture of one of the chainplates that I removed from my > boat so that you can see what you are dealing with. The chainplate, which is > really just a tang that has been bent so that it goes through the deck and > wraps under the deck core material (plywood in my case) and is held by a > small screw that goes through the hole in the end. Mine all worked loose and > as a result it was impossible to make a permanent seal where the tang went > through the deck. I had no idea what I was dealing with and so I ground out > the deck to get the things out. I now know that it probably would have been > much easier to remove them by cutting through the headliner, remove the > screw and push the chainplate out from below. I also attached a picture of > the holes I created and then has to patch and subsequently repaint my entire > deck - which I was going to to anyway because of a variety of other repairs > I made to the deck. > > I didn't want to keep the old chainplates so I installed new ones. For these > I used forged eyebolts made by Blue Wave. The advantage of this arrangement > is that I could install it through a hole that I drilled through the deck > and core that I filled with epoxy and sealed with butyl tape. It should be > watertight. I made spacers of composite lumber cut at an angel to fit the > slope of the liner and that , along with large stainless steel fender > washers should be at least as strong as the original tang and with little, > if any, room to wiggle loose. I have attached a picture of the deck after it > was rebuilt showing the new chainplates installed. That said, I have not yet > completed my rebuild and have not tested this new arrangement on the water. > > When you say that "one of the chainplates pulled the fibreglass" I am not > sure what you are describing. If you mean that the fibreglass lifted than I > would be concerned that the core material has become rotten. Water egress > into the deck was a concern that prompted me to make my repairs although it > turned out that I had no water damage to the core.. If the core is wet and > rotten you have a much larger problem to address. Let me know if that is the > case and I might be able to make some suggestions as that was a problem that > I had to address one the fore deck and in the process eventually discovered > that I definitely did it the hard way. The problem is that you can't see > what is happening under the deck. > > Pictures of the damage would be very useful. > > Take care, > Graham > > Graham Stewart > Agile. R22, 1976 > Kingston Ontario Canada > > > > > > -----Original Message----- > From: Rhodes22-list [mailto:rhodes22-list-bounces at rhodes22.org] On Behalf Of > Luis Guzman > Sent: March 8, 2017 7:40 PM > To: rhodes22-list at rhodes22.org > Subject: [Rhodes22-list] Subject: lower stays > > Hello everyone. I have been off the list for a long time, but I"m still > sailing. > > One of the aft-lower stay pulled the fiberglass on the cabin top, and I'm > looking for information on where the chain plate is located, and how to > repair this. > > For the pnes who do not know me pr remember me, I'm in Bradenyon, FL, and I > own a 1983 Rhodes 22. > __________________________________________________ > To subscribe/unsubscribe go to > http://www.rhodes22.org/mailman/listinfo/rhodes22-list > > For the list Charter and help with using the mailing list and archives go to > http://www.rhodes22.org/list > __________________________________________________ > -------------- next part -------------- > A non-text attachment was scrubbed... > Name: Chainplate.JPG > Type: image/jpeg > Size: 89771 bytes > Desc: not available > URL: <http://rhodes22.org/pipermail/rhodes22-list/attachments/20170308/abeaab30/attachment.jpe> > -------------- next part -------------- > A non-text attachment was scrubbed... > Name: Filling lower shroud holes.JPG > Type: image/jpeg > Size: 69382 bytes > Desc: not available > URL: <http://rhodes22.org/pipermail/rhodes22-list/attachments/20170308/abeaab30/attachment-0001.jpe> > -------------- next part -------------- > A non-text attachment was scrubbed... > Name: Lower chainplates with composite spacers.jpg > Type: image/jpeg > Size: 591134 bytes > Desc: not available > URL: <http://rhodes22.org/pipermail/rhodes22-list/attachments/20170308/abeaab30/attachment.jpg> > -------------- next part -------------- > A non-text attachment was scrubbed... > Name: Non-skid port side September 2015.jpg > Type: image/jpeg > Size: 368773 bytes > Desc: not available > URL: <http://rhodes22.org/pipermail/rhodes22-list/attachments/20170308/abeaab30/attachment-0001.jpg> > -------------- next part -------------- > A non-text attachment was scrubbed... > Name: Blue wave forged eye bolts for lower chainplates.jpg > Type: image/jpeg > Size: 7070 bytes > Desc: not available > URL: <http://rhodes22.org/pipermail/rhodes22-list/attachments/20170308/abeaab30/attachment-0002.jpg> > __________________________________________________ > To subscribe/unsubscribe go to http://www.rhodes22.org/mailman/listinfo/rhodes22-list > > For the list Charter and help with using the mailing list and archives go to http://www.rhodes22.org/list > __________________________________________________
To use your email application to send a messsage to the webmaster rather than this form, .
Your post is being sent... 