The Rhodes 22 Discussion Group R22 Discussion Group

The Rhodes 22 Discussion Group


< prior

Back to Month

Go to Thread

Member Picture

Weiss, Robert L



furling tube problem

2017-03-28; 19:35:13 EDT

Member Since

2016-05-03

Posts: 138

I have a 175% Genoa that I took off for the winter. When I went to put it on
today, I was unable to pull it all the way up because part of the plastic
furling tube that is secured with screws is warped and pulled apart in two
places. The lower one (pictured)  is not a problem and the sail gets by it,
but one a little farther up has a lower piece pulled away, so the sail
doesn't stay in the slot and sticks there. I'll attach a photo which is of
the lower piece since that is the only one I could get a decent shot of. if
you picture the same kind of problem but with the bottom side sticking out,
that is where my problem is. So, I guess I plan to take the mast down this
weekend and try to repair the furling tube. Anyone else had this problem? Is
there something I should do beside try to replace the screw that has
obviously pulled out? Would it help to try to glue something on the side to
hold the warped piece in place? If so, do you have any suggestions for kind
of glue to use?
Bob

IMG_1404.jpg





-----
Bob Weiss
Beach Spring
1998 Rhodes 22 Recycled in 2014
--
View this message in context: http://rhodes-22.1065344.n5.nabble.com/furling-tube-problem-tp52969.html
Sent from the Rhodes 22 mailing list archive at Nabble.com.
See the original archive post
×

Message to Webmaster:

To use your email application to send a messsage to the webmaster rather than this form, .



×

Post to the Rhodes 22 Email List:



×

Sending Post:

Your post is being sent... waiting