2017-04-29; 14:54:39 EDT
Member Since
2008-02-18
Posts: 319
I've had my CB out 3 times in the 13 years I've had her,twice hen I knocked a hole in the CB cap. First time when I launched her and forgot to secure the centerboard pendent, and the CB hit the ground as it was sliding off the trailer, and the he full weight of the boat was on the CB cap. It put a dent in the cap bout the size if a baseball and cracked the top of the dent enough to to let about 2" of water cover the cabin floor , before I noticed it. The extra water in the boat made it a little bit of a low rider and a lot harder to get back on the trailer. I just put a few layer of fiberglass over the dent and cracks and that lasted about 5 years, when I hit something underwater that jammed the CB up against the cap with enough to force to recrack the cap dent. The first time I removed the cap ,was when I removed all the bottom paint to change from ablative to hard paint. I replaced the gasket the 1st and 3rd times, and I used silicone sealent RTV ( room temperature valconization) ,top and bottom of the gasket, each time. The last time, last year, the screw holes were just about stripped, so I thru-bolted it back down, except for 4 or 6 holes around the CB pivot pin where there was not enough bottom flange to get a nut on the bottom. I filled those holes with epoxy and redrilled them. If you are not thru bolted, it would be smart to notice as you are tightening the screws, that they are getting tighter and not stripping out the fiberglass. When you start your second round of tightening, if you back off the screw about a 1/4 of a turn, before tightening down, you eliminate the break- away torque and get a better feel for how tight you are getting the screw. Whether or not you use sealant, I would highly recommend once you get the cap secured, don't reassemble the rest of the interior. Instead , take it to a close lake,and float it around for an hour or two. Take a flashlight and some paper towels and dab all around the edges of the cap to check for leaks. If it leaks,tighten the fasteners around the leak. If you can't get it to stop, new gasket and/ or sealent. Jerry Lowe ello Rhodies: image.jpegSee the original archive post