The Rhodes 22 Discussion Group R22 Discussion Group

The Rhodes 22 Discussion Group


< prior

Back to Month

Go to Thread

Member Picture

joedempsey



New Teak

2017-05-04; 15:22:58 EDT

Member Since

2016-12-14

Posts: 257

  The two cables connect to the starboard side of the motor. The thru hull opening through the transom is on the port side of the motor lift.  It doesn't seem feasible for those cables to make the 180 back to the starboard side and run to the remote box. Should cables go over or through transom. If through, does lift put too much bind in them? I'm just not seeing how to feed cables to get under cockpit seats.                                                                                                                                                                         Sent from my BlackBerry - the most secure mobile device                                                                                                                                                                            From: ml+s1065344n53140h35 at n5.nabble.com Sent: May 4, 2017 12:49 PM To: joedempsey at hughes.net Subject: Re: New Teak   

	JP,
How similar is your new motor to your old motor?  I have an Evinrude which
is a no-brainer for remote control.
Rick
See the original archive post
×

Message to Webmaster:

To use your email application to send a messsage to the webmaster rather than this form, .



×

Post to the Rhodes 22 Email List:



×

Sending Post:

Your post is being sent... waiting