2017-05-31; 12:53:23 EDT
Member Since
2012-09-10
Posts: 48
Attached is a picture of the hoist I use in place of the Winch that came with our 2012 factory refurbished boat. The winch that came with the boat has a 3000 lb capacity with a remote control as the only on off switch. I had no complaint with the idea. The winch strap raises the motor to a top limit and a bump stop allows it to tilt the motor automatically. But, without an automatic kill switch at the top limit or a manual back-up shut off switch for the remote, the winch had the power to rip the entire assembly out of the stern if it did not get shut off just right, got sat on, got dropped or got stuck in the on position for any number of reasons. After several trial uses under sail it was clear there was a real risk of damage to the boat from the winch. I removed the winch and replaced it with the pulley system you see pictured. My Tohatsu 6 hp 4 stroke is 58 lbs and pulls up easily with one hand. Every other 4 stroke engine we looked at was in the 100 lb range. This pulley will easily handle that extra weight. The other reason for the change was that the top limit of the winch was about 2 to 3 inches lower than the Tohatsu needed for comfortable forward tilt room. If there had been a reliable safety stop for the winch and it lifted the engine a bit higher, I may have kept using it. But, I have had the 4 double pulley lift now for 5 years in salt water conditions with no trouble at all and would not even consider going back to a winch. Jay Port Angeles, WA -------------------------------------------------- From: "UWILLC via Rhodes22-list" <rhodes22-list at rhodes22.org> Sent: Wednesday, May 31, 2017 3:19 AM To: <rhodes22-list at rhodes22.org> Subject: Re: [Rhodes22-list] Replace or fix outboard motor bracket? Engine Hoist 2 small.jpgSee the original archive post