The Rhodes 22 Discussion Group R22 Discussion Group

The Rhodes 22 Discussion Group


< prior

Back to Month

Go to Thread

Member Picture

Chris Geankoplis



Cabin hatch lock

2017-07-14; 14:55:11 EDT

Member Since

2004-04-05

Posts: 2062

Hey Peter,
               There was a mm or so slop in mine too that I installed
yesterday.  I use some 3/4" heat shrink sleeve  (for electrical
connections) cut to length.  I first wrapped the lock barrel with a piece
of alum coke can material to prevent the thermal glue on the sleeve from
interfering with the locking pin at the bottom of the side of the barrel.
This both eliminated the slop and sealed the lock from much of the weather
so it is nice and tight.  Didn't figure out about the glue problem the
first time around. (sheepish grin).

Chris Geankoplis

See the original archive post
×

Message to Webmaster:

To use your email application to send a messsage to the webmaster rather than this form, .



×

Post to the Rhodes 22 Email List:



×

Sending Post:

Your post is being sent... waiting