< prior
Back to Month
Go to Thread
2017-08-14; 15:34:17 EDT
Member Since
2013-07-01
Posts: 438
I was thinking of no blocks. Has anyone changed their old school set up to omit the blocks? Does the Diamond Board have any blocks? thanks ric sv Dadventure Hampton BaysSee the original archive post
> On Aug 14, 2017, at 3:23 PM, Richard Beytagh <rbeytagh at gmail.com> wrote: > > I have the same set up on Waif - 1984 hull - and I am going through the > possess of rebuilding my center-board cap. Long story, but the board came > down when I was launching -'nuff said. > > I too have 2 blocks and I think I will leave them as is - Stan in his > infinite wisdom spec'ed it this way. I suspect you could get away with one > block if you choose to go this route. > > > > <http://www.avg.com/email-signature?utm_medium=email&utm_source=link&utm_campaign=sig-email&utm_content=webmail> > Virus-free. > www.avg.com > <http://www.avg.com/email-signature?utm_medium=email&utm_source=link&utm_campaign=sig-email&utm_content=webmail> > <#DAB4FAD8-2DD7-40BB-A1B8-4E2AA1F9FDF2> > > > > ~~~ _/) ~~~ > > Richard Beytagh > Phone: 828 337 0180 > > On Mon, Aug 14, 2017 at 1:57 PM, Richard Stott <ric at stottarchitecture.com> > wrote: > >> I have an old style board. Its not that heavy, I’ve opened the gasketed >> top cap, removed the CB and repaired the cap, which was cracked due to a >> grounding. I refurbished the trunk and replaced the hose parts which >> occupy the slots, installed to prevent the board from sliding up in its >> tracks and hitting the cap - which is apparently what happened. Anyway - >> the board is not that heavy and although I replaced the line and blocks, I >> questioned myself at the time, that all that purchase adds more friction >> than the weight it presumably helps to lift. >> It sounds like the newer diamond board does not use any blocks and is a >> direct path from the back of the board with no turning blocks. >> Ric >> sv Dadventure >> >> >> >> >> >> >>> On Aug 14, 2017, at 1:25 PM, Richard Beytagh <rbeytagh at gmail.com> wrote: >>> >>> Can I suggest that you reeve the pennant with plenty to spare and when >> you >>> have the boat in the water and can test it, you cut it length...just a >>> suggestion >>> >>> <http://www.avg.com/email-signature?utm_medium=email& >> utm_source=link&utm_campaign=sig-email&utm_content=webmail> >>> Virus-free. >>> www.avg.com >>> <http://www.avg.com/email-signature?utm_medium=email& >> utm_source=link&utm_campaign=sig-email&utm_content=webmail> >>> <#DAB4FAD8-2DD7-40BB-A1B8-4E2AA1F9FDF2> >>> >>> >>> >>> ~~~ _/) ~~~ >>> >>> Richard Beytagh >>> Phone: 828 337 0180 >>> >>> On Mon, Aug 14, 2017 at 12:55 PM, Graham Stewart <gstewart8 at cogeco.ca> >>> wrote: >>> >>>> Jay: >>>> I had misunderstood your original message. >>>> >>>> I just measured my tether. With the board up I have 68" of line showing. >>>> With board down all but a few inches are used. >>>> >>>> My boat does not have the diamond board - if that makes a difference. >>>> >>>> >>>> Graham Stewart >>>> Agile. R22, 1976 >>>> Kingston Ontario Canada >>>> >>>> >>>> >>>> >>>> -----Original Message----- >>>> From: Rhodes22-list [mailto:rhodes22-list-bounces at rhodes22.org] On >> Behalf >>>> Of Jay Friedland >>>> Sent: August 13, 2017 10:46 PM >>>> To: The Rhodes 22 Email List >>>> Subject: Re: [Rhodes22-list] CB pendant length >>>> >>>> Thanlks, Graham. >>>> >>>> I had some big differences over what you have. My first 1986 R22 had the >>>> original CB, and I added a single block. It went through at least >> 18-20” of >>>> travel. This new factory-replaced CB pulls fully down over the 38” >> length. >>>> I just don’t know where the sweet spot or usable depth is hit. >>>> >>>> Jay >>>> >>>> >>>>> On Aug 13, 2017, at 8:26 PM, Graham Stewart <gstewart8 at cogeco.ca> >> wrote: >>>>> >>>>> Jay: >>>>> The line that raises my centreboard is about 12'. It has to pass >> through >>>> three blocks before the final block at the base of the tube leading to >> the >>>> cockpit. When the centerboard is down I have very little line that is >> free. >>>> I have the original centreboard but I think the line route s the same >> for >>>> the diamond board. >>>>> >>>>> Graham Stewart >>>>> Agile. R22, 1976 >>>>> Kingston Ontario Canada >>>>> >>>>> >>>>> >>>>> -----Original Message----- >>>>> From: Rhodes22-list [mailto:rhodes22-list-bounces at rhodes22.org] On >>>>> Behalf Of Jay Friedland >>>>> Sent: August 13, 2017 12:11 PM >>>>> To: The Rhodes 22 Email List >>>>> Subject: [Rhodes22-list] CB pendant length >>>>> >>>>> Wondering about the optimum length for best use of the diamond board. I >>>> have 38” (full travel, stopper knot to exit hole) but have measured >>>> everywhere from 26” on up. Most have been factory set. >>>>> >>>>> Jay Friedland >>>>> s/v Wanderlust ‘97 >>>>> __________________________________________________ >>>>> To subscribe/unsubscribe go to >>>>> http://www.rhodes22.org/mailman/listinfo/rhodes22-list >>>>> >>>>> For the list Charter and help with using the mailing list and archives >>>>> go to http://www.rhodes22.org/list >>>>> __________________________________________________ >>>>> >>>>> __________________________________________________ >>>>> To subscribe/unsubscribe go to >>>>> http://www.rhodes22.org/mailman/listinfo/rhodes22-list >>>>> >>>>> For the list Charter and help with using the mailing list and archives >>>>> go to http://www.rhodes22.org/list >>>>> __________________________________________________ >>>> >>>> __________________________________________________ >>>> To subscribe/unsubscribe go to http://www.rhodes22.org/ >>>> mailman/listinfo/rhodes22-list >>>> >>>> For the list Charter and help with using the mailing list and archives >> go >>>> to http://www.rhodes22.org/list ______________________________ >>>> ____________________ >>>> >>>> __________________________________________________ >>>> To subscribe/unsubscribe go to http://www.rhodes22.org/ >>>> mailman/listinfo/rhodes22-list >>>> >>>> For the list Charter and help with using the mailing list and archives >> go >>>> to http://www.rhodes22.org/list >>>> __________________________________________________ >>>> >>> __________________________________________________ >>> To subscribe/unsubscribe go to http://www.rhodes22.org/ >> mailman/listinfo/rhodes22-list >>> >>> For the list Charter and help with using the mailing list and archives >> go to http://www.rhodes22.org/list >>> __________________________________________________ >> >> >> >> Richard F. Stott, AIA, LEED AP >> ric at stottarchitecture.com >> o- 631-283-1777 >> c- 516-965-3164 >> >> >> >> >> __________________________________________________ >> To subscribe/unsubscribe go to http://www.rhodes22.org/ >> mailman/listinfo/rhodes22-list >> >> For the list Charter and help with using the mailing list and archives go >> to http://www.rhodes22.org/list >> __________________________________________________ >> > __________________________________________________ > To subscribe/unsubscribe go to http://www.rhodes22.org/mailman/listinfo/rhodes22-list > > For the list Charter and help with using the mailing list and archives go to http://www.rhodes22.org/list > __________________________________________________ Richard F. Stott, AIA, LEED AP ric at stottarchitecture.com o- 631-283-1777 c- 516-965-3164
To use your email application to send a messsage to the webmaster rather than this form, .
Your post is being sent... 