< prior
Back to Month
Go to Thread
2017-08-14; 20:38:44 EDT
Member Since
2002-08-24
Posts: 357
Sooo, Don & Co., what length of pendant did wind up with, giving you full travel? Jay Friedland S/V WanderlustSee the original archive post
> On Aug 14, 2017, at 6:52 PM, Richard Stott <ric at stottarchitecture.com> wrote: > > All in all - me too. > I’m fine with what I got. > Ric > sv > Dadventure > >> On Aug 14, 2017, at 4:35 PM, Richard Beytagh <rbeytagh at gmail.com> wrote: >> >> If you eliminated the blocks all together you would not be able to get a >> direct vertical pull on the CB. You could laminate a S/S tube like there is >> in the aft section of the lid as a tuning point but might as well keep the >> blocks. I don't have the diamond board so I cant advise on that. Quite >> frankly the traditional CB works fine for me and is useful as a shallow >> water warning when it scrapes on the bottom. >> >> <http://www.avg.com/email-signature?utm_medium=email&utm_source=link&utm_campaign=sig-email&utm_content=webmail> >> Virus-free. >> www.avg.com >> <http://www.avg.com/email-signature?utm_medium=email&utm_source=link&utm_campaign=sig-email&utm_content=webmail> >> <#DAB4FAD8-2DD7-40BB-A1B8-4E2AA1F9FDF2> >> >> >> >> ~~~ _/) ~~~ >> >> Richard Beytagh >> Phone: 828 337 0180 >> >> On Mon, Aug 14, 2017 at 3:34 PM, Richard Stott <ric at stottarchitecture.com> >> wrote: >> >>> I was thinking of no blocks. Has anyone changed their old school set up to >>> omit the blocks? >>> Does the Diamond Board have any blocks? >>> thanks >>> ric >>> sv Dadventure >>> Hampton Bays >>> >>> >>> >>>> On Aug 14, 2017, at 3:23 PM, Richard Beytagh <rbeytagh at gmail.com> wrote: >>>> >>>> I have the same set up on Waif - 1984 hull - and I am going through the >>>> possess of rebuilding my center-board cap. Long story, but the board came >>>> down when I was launching -'nuff said. >>>> >>>> I too have 2 blocks and I think I will leave them as is - Stan in his >>>> infinite wisdom spec'ed it this way. I suspect you could get away with >>> one >>>> block if you choose to go this route. >>>> >>>> >>>> >>>> <http://www.avg.com/email-signature?utm_medium=email& >>> utm_source=link&utm_campaign=sig-email&utm_content=webmail> >>>> Virus-free. >>>> www.avg.com >>>> <http://www.avg.com/email-signature?utm_medium=email& >>> utm_source=link&utm_campaign=sig-email&utm_content=webmail> >>>> <#DAB4FAD8-2DD7-40BB-A1B8-4E2AA1F9FDF2> >>>> >>>> >>>> >>>> ~~~ _/) ~~~ >>>> >>>> Richard Beytagh >>>> Phone: 828 337 0180 >>>> >>>> On Mon, Aug 14, 2017 at 1:57 PM, Richard Stott < >>> ric at stottarchitecture.com> >>>> wrote: >>>> >>>>> I have an old style board. Its not that heavy, I’ve opened the gasketed >>>>> top cap, removed the CB and repaired the cap, which was cracked due to a >>>>> grounding. I refurbished the trunk and replaced the hose parts which >>>>> occupy the slots, installed to prevent the board from sliding up in its >>>>> tracks and hitting the cap - which is apparently what happened. Anyway >>> - >>>>> the board is not that heavy and although I replaced the line and >>> blocks, I >>>>> questioned myself at the time, that all that purchase adds more friction >>>>> than the weight it presumably helps to lift. >>>>> It sounds like the newer diamond board does not use any blocks and is a >>>>> direct path from the back of the board with no turning blocks. >>>>> Ric >>>>> sv Dadventure >>>>> >>>>> >>>>> >>>>> >>>>> >>>>> >>>>>> On Aug 14, 2017, at 1:25 PM, Richard Beytagh <rbeytagh at gmail.com> >>> wrote: >>>>>> >>>>>> Can I suggest that you reeve the pennant with plenty to spare and when >>>>> you >>>>>> have the boat in the water and can test it, you cut it length...just a >>>>>> suggestion >>>>>> >>>>>> <http://www.avg.com/email-signature?utm_medium=email& >>>>> utm_source=link&utm_campaign=sig-email&utm_content=webmail> >>>>>> Virus-free. >>>>>> www.avg.com >>>>>> <http://www.avg.com/email-signature?utm_medium=email& >>>>> utm_source=link&utm_campaign=sig-email&utm_content=webmail> >>>>>> <#DAB4FAD8-2DD7-40BB-A1B8-4E2AA1F9FDF2> >>>>>> >>>>>> >>>>>> >>>>>> ~~~ _/) ~~~ >>>>>> >>>>>> Richard Beytagh >>>>>> Phone: 828 337 0180 >>>>>> >>>>>> On Mon, Aug 14, 2017 at 12:55 PM, Graham Stewart <gstewart8 at cogeco.ca> >>>>>> wrote: >>>>>> >>>>>>> Jay: >>>>>>> I had misunderstood your original message. >>>>>>> >>>>>>> I just measured my tether. With the board up I have 68" of line >>> showing. >>>>>>> With board down all but a few inches are used. >>>>>>> >>>>>>> My boat does not have the diamond board - if that makes a difference. >>>>>>> >>>>>>> >>>>>>> Graham Stewart >>>>>>> Agile. R22, 1976 >>>>>>> Kingston Ontario Canada >>>>>>> >>>>>>> >>>>>>> >>>>>>> >>>>>>> -----Original Message----- >>>>>>> From: Rhodes22-list [mailto:rhodes22-list-bounces at rhodes22.org] On >>>>> Behalf >>>>>>> Of Jay Friedland >>>>>>> Sent: August 13, 2017 10:46 PM >>>>>>> To: The Rhodes 22 Email List >>>>>>> Subject: Re: [Rhodes22-list] CB pendant length >>>>>>> >>>>>>> Thanlks, Graham. >>>>>>> >>>>>>> I had some big differences over what you have. My first 1986 R22 had >>> the >>>>>>> original CB, and I added a single block. It went through at least >>>>> 18-20” of >>>>>>> travel. This new factory-replaced CB pulls fully down over the 38” >>>>> length. >>>>>>> I just don’t know where the sweet spot or usable depth is hit. >>>>>>> >>>>>>> Jay >>>>>>> >>>>>>> >>>>>>>> On Aug 13, 2017, at 8:26 PM, Graham Stewart <gstewart8 at cogeco.ca> >>>>> wrote: >>>>>>>> >>>>>>>> Jay: >>>>>>>> The line that raises my centreboard is about 12'. It has to pass >>>>> through >>>>>>> three blocks before the final block at the base of the tube leading to >>>>> the >>>>>>> cockpit. When the centerboard is down I have very little line that is >>>>> free. >>>>>>> I have the original centreboard but I think the line route s the same >>>>> for >>>>>>> the diamond board. >>>>>>>> >>>>>>>> Graham Stewart >>>>>>>> Agile. R22, 1976 >>>>>>>> Kingston Ontario Canada >>>>>>>> >>>>>>>> >>>>>>>> >>>>>>>> -----Original Message----- >>>>>>>> From: Rhodes22-list [mailto:rhodes22-list-bounces at rhodes22.org] On >>>>>>>> Behalf Of Jay Friedland >>>>>>>> Sent: August 13, 2017 12:11 PM >>>>>>>> To: The Rhodes 22 Email List >>>>>>>> Subject: [Rhodes22-list] CB pendant length >>>>>>>> >>>>>>>> Wondering about the optimum length for best use of the diamond >>> board. I >>>>>>> have 38” (full travel, stopper knot to exit hole) but have measured >>>>>>> everywhere from 26” on up. Most have been factory set. >>>>>>>> >>>>>>>> Jay Friedland >>>>>>>> s/v Wanderlust ‘97 >>>>>>>> __________________________________________________ >>>>>>>> To subscribe/unsubscribe go to >>>>>>>> http://www.rhodes22.org/mailman/listinfo/rhodes22-list >>>>>>>> >>>>>>>> For the list Charter and help with using the mailing list and >>> archives >>>>>>>> go to http://www.rhodes22.org/list >>>>>>>> __________________________________________________ >>>>>>>> >>>>>>>> __________________________________________________ >>>>>>>> To subscribe/unsubscribe go to >>>>>>>> http://www.rhodes22.org/mailman/listinfo/rhodes22-list >>>>>>>> >>>>>>>> For the list Charter and help with using the mailing list and >>> archives >>>>>>>> go to http://www.rhodes22.org/list >>>>>>>> __________________________________________________ >>>>>>> >>>>>>> __________________________________________________ >>>>>>> To subscribe/unsubscribe go to http://www.rhodes22.org/ >>>>>>> mailman/listinfo/rhodes22-list >>>>>>> >>>>>>> For the list Charter and help with using the mailing list and archives >>>>> go >>>>>>> to http://www.rhodes22.org/list ______________________________ >>>>>>> ____________________ >>>>>>> >>>>>>> __________________________________________________ >>>>>>> To subscribe/unsubscribe go to http://www.rhodes22.org/ >>>>>>> mailman/listinfo/rhodes22-list >>>>>>> >>>>>>> For the list Charter and help with using the mailing list and archives >>>>> go >>>>>>> to http://www.rhodes22.org/list >>>>>>> __________________________________________________ >>>>>>> >>>>>> __________________________________________________ >>>>>> To subscribe/unsubscribe go to http://www.rhodes22.org/ >>>>> mailman/listinfo/rhodes22-list >>>>>> >>>>>> For the list Charter and help with using the mailing list and archives >>>>> go to http://www.rhodes22.org/list >>>>>> __________________________________________________ >>>>> >>>>> >>>>> >>>>> Richard F. Stott, AIA, LEED AP >>>>> ric at stottarchitecture.com >>>>> o- 631-283-1777 >>>>> c- 516-965-3164 >>>>> >>>>> >>>>> >>>>> >>>>> __________________________________________________ >>>>> To subscribe/unsubscribe go to http://www.rhodes22.org/ >>>>> mailman/listinfo/rhodes22-list >>>>> >>>>> For the list Charter and help with using the mailing list and archives >>> go >>>>> to http://www.rhodes22.org/list >>>>> __________________________________________________ >>>>> >>>> __________________________________________________ >>>> To subscribe/unsubscribe go to http://www.rhodes22.org/ >>> mailman/listinfo/rhodes22-list >>>> >>>> For the list Charter and help with using the mailing list and archives >>> go to http://www.rhodes22.org/list >>>> __________________________________________________ >>> >>> >>> >>> Richard F. Stott, AIA, LEED AP >>> ric at stottarchitecture.com >>> o- 631-283-1777 >>> c- 516-965-3164 >>> >>> >>> >>> >>> __________________________________________________ >>> To subscribe/unsubscribe go to http://www.rhodes22.org/ >>> mailman/listinfo/rhodes22-list >>> >>> For the list Charter and help with using the mailing list and archives go >>> to http://www.rhodes22.org/list >>> __________________________________________________ >>> >> __________________________________________________ >> To subscribe/unsubscribe go to http://www.rhodes22.org/mailman/listinfo/rhodes22-list >> >> For the list Charter and help with using the mailing list and archives go to http://www.rhodes22.org/list >> __________________________________________________ > > > > Richard F. Stott, AIA, LEED AP > ric at stottarchitecture.com > o- 631-283-1777 > c- 516-965-3164 > > > > > __________________________________________________ > To subscribe/unsubscribe go to http://www.rhodes22.org/mailman/listinfo/rhodes22-list > > For the list Charter and help with using the mailing list and archives go to http://www.rhodes22.org/list > __________________________________________________
To use your email application to send a messsage to the webmaster rather than this form, .
Your post is being sent... 