The Rhodes 22 Discussion Group R22 Discussion Group

The Rhodes 22 Discussion Group


< prior

Back to Month

Go to Thread

Member Picture

Mark Olson



rigging my Rhodes

2017-10-24; 14:40:16 EDT

Member Since

2016-06-29

Posts: 30

You detatch the block for the boom, pull out the quick pins, take out the 
old traveler, put in the new traveler, replace the quick pins and reattach 
the block.  Mine took longer as the previous owner cut the quick pins off 
flush.  I used a 1/8" drill bit.  Once I drilled into the pin a little it 
turned with the bit and I was able to pull it out with the drill while 
keeping the pin spinning at a low speed.

Mark


See the original archive post
×

Message to Webmaster:

To use your email application to send a messsage to the webmaster rather than this form, .



×

Post to the Rhodes 22 Email List:



×

Sending Post:

Your post is being sent... waiting