The Rhodes 22 Discussion Group R22 Discussion Group

The Rhodes 22 Discussion Group


< prior

Back to Month

Go to Thread

Member Picture

Graham Stewart



Curved Rudder | 84 Rhodes 22

2017-12-05; 16:59:03 EST

Member Since

2005-04-29

Posts: 816

Bob:
It is hard to see the twist from the photo. Mine (1976) is made of a
fibreglass shell with a metal (lead?) weight at the tip and some kind of
fill inside. I found that there were a lot of large voids inside that I
located by drilling holes and tapping. I filled what I could find with
epoxy. 

It is hard to see how mine could bend without the gel coat cracking. You
might remove all of the paint and look for damage.

I can't think of any way to straighten the rudder. If it affects the sailing
and handling of the boat you will probably need to have Stan replace it. If
it doesn't affect the sailing, I would probably ignore it for a while and
see what happens.

Is it possible that the bolt at the pivot point is loose and holding the
rudder at a bit of an angle?
Graham

Graham Stewart
Agile. R22, 1976
Kingston Ontario Canada



See the original archive post
×

Message to Webmaster:

To use your email application to send a messsage to the webmaster rather than this form, .



×

Post to the Rhodes 22 Email List:



×

Sending Post:

Your post is being sent... waiting