The Rhodes 22 Discussion Group R22 Discussion Group

The Rhodes 22 Discussion Group


< prior

Back to Month

Go to Thread

Member Picture

Ric Stott



The list has been very quiet

2018-01-19; 12:13:59 EST

Member Since

2013-07-01

Posts: 438

Thanks MIke
I hope to have the re-built trailer ready for spring launch.
The extension tube was rusted severely. 
It was an engineering challenge to get it free from the housing, and I was considering replacing it - with your comments on record, that’s on the list now too. 
Another item I’ve been wonting to replace, but haven’t gotten around to, is the motor lift. 
The original '84 lift does not extend high enough to pull the prop clear of the water and I have to tilt the motor to its max position while underway and I’m often alone.
I’m still pretty agile, but that’s not easy.  
I want a manual  lift of Stan’s design the accommodates my extra long shaft 8HP.   (I don’t like the electric ones I’ve seen)
I  spoke to Stan a couple years ago. For reasons never clear to me,  he was reluctant to sell me one or the parts, unless the boat was down there.
I also want to re-configure the stern rail so there is break in the top rail where the ladder lifts.
Climbing aboard from the beach, over the top of the rail, especially with the new traveller in the way, requires gymnastics that my wife refuses to to accept. 
I really like Stan’s modern design with the curved rail and seats, but do’t want to spend the money on an entirely new stern rail. 
Do you know anyone near the east end that could help with that?   A traveling TIG welder? 
 
I’ll send some pics of the trailer when it’s  done. 
Ric 
s/v Dadventure 


Richard Stott
www.stottarchitecture.com
Office	631-283-1777
Cell		516-965-3164 



See the original archive post
×

Message to Webmaster:

To use your email application to send a messsage to the webmaster rather than this form, .



×

Post to the Rhodes 22 Email List:



×

Sending Post:

Your post is being sent... waiting