The Rhodes 22 Discussion Group R22 Discussion Group

The Rhodes 22 Discussion Group


< prior

Back to Month

Go to Thread

Member Picture

Ric Stott



The list has been very quiet

2018-01-22; 07:59:07 EST

Member Since

2013-07-01

Posts: 438

Sure - I hooked a 3000# come-along to the neck(housing) of the tube. I forget how, I might have used a small piece of chain. Then attached the extended come along to an ‘s’hook toward the end of the 2x2 tube and began to put some pull pressure on. With tension on it, I heated the housing, banged, scraped, pulled, banged, heated and so on. After about 20 minutes of high pressure and persuasion, the tube began to move. Once it move about 12 inches it was free and slid easily. 
Check the bottom of the housing. Mine was rusted through and I cut some of the heavy rust off with a 4” grinder.  
Good luck
Ric
S/v Dadventure

Sent from my iPhone

See the original archive post
×

Message to Webmaster:

To use your email application to send a messsage to the webmaster rather than this form, .



×

Post to the Rhodes 22 Email List:



×

Sending Post:

Your post is being sent... waiting