The Rhodes 22 Discussion Group R22 Discussion Group

The Rhodes 22 Discussion Group


< prior

Back to Month

Go to Thread

Member Picture

Graham Stewart



Rubber gasket

2018-08-18; 18:40:44 EDT

Member Since

2005-04-29

Posts: 816

Just so that there is no confusion, I did make a neoprene gasket and it is installed. It is 3/16 thick but has a fine ribbed pattern that I think did not compress enough to make a perfect seal. It might also be too hard. So I am only using the butyl to give the neoprene a smoother surface - not substituting the neoprene with the butyl. Nevertheless, I think I will replace the gasket when I can find a Canadian source.

Another issue that might explain my difficulty getting a good seal is that it looks to me like the flange on the cap might have been trimmed at some point. The lip is only about 1 1/4 inch wide and allows for only a single row of bolts. The base is quite a bit wider and appears to have had a second row of bolts at some point. It makes sense that both parts would be the same width.

I really don't want to take this apart again to replace the gasket and rebuild the cap.

Graham

See the original archive post
×

Message to Webmaster:

To use your email application to send a messsage to the webmaster rather than this form, .



×

Post to the Rhodes 22 Email List:



×

Sending Post:

Your post is being sent... waiting