The Rhodes 22 Discussion Group R22 Discussion Group

The Rhodes 22 Discussion Group


< prior

Back to Month

Go to Thread

Member Picture

Patrick Cheung



Rubber gasket

2018-08-18; 20:01:09 EDT

Member Since

2010-03-25

Posts: 31

Thank you for sharing Curtis, I was tempted to use this sponge rubber, but
I chose to stay with solid neoprene. My boat stays in water all summer.

On the subject of wet bilge, when I open up the cap, there is this cute
little V-block, inverted. I think it serves to home in the center board
when it is raised.
Two screws are used to secure this V block, driven through the side wall at
a 45 degree. This is perfect for water coming into the bilge. I found
another rusted screw tip 5 mm away. Now, I can guarantee Stan is incapable
of doing this. My boat is built for Stan, it is NOT built by Stan.
Now, I wonder what Stan use to secure this V block, if any. Perhaps 5200 ?

patrick


See the original archive post
×

Message to Webmaster:

To use your email application to send a messsage to the webmaster rather than this form, .



×

Post to the Rhodes 22 Email List:



×

Sending Post:

Your post is being sent... waiting