The Rhodes 22 Discussion Group R22 Discussion Group

The Rhodes 22 Discussion Group


< prior

Back to Month

Go to Thread

Member Picture

ROGER PIHLAJA



Curved Rudder | 84 Rhodes 22

2018-12-11; 17:11:40 EST

Member Since

2002-08-01

Posts: 1438

Bob,



The rudder blade is pretty stiff.  However, you might try this:



Set the rudder blade between saw horses with the curved side up.  Set a straight edge down the length of the rudder blade.  Measure the maximum draft between the straight edge and the rudder blade.  Draft is the perpendicular distance between the straight edge and the rudder blade at any given point.  Flip the rudder blade over and, using some sort of strap to wrap around the rudder blade at the point of maximum draft, add load beneath the rudder blade until the rudder blade straightens out.  It might require a couple hundred lbs.  Note: If you hear cracking; then, stop!  Allow the rudder blade to sit loaded up like this for several weeks.  Then, unload it and remeasure the maximum draft.  Note: This procedure is more likely to work if you can do it in a warm place, say > 70 deg F.



Roger Pihlaja

SV Dynamic Equilibrium



Sent from Mail<https://go.microsoft.com/fwlink/?LinkId=550986> for Windows 10



See the original archive post
×

Message to Webmaster:

To use your email application to send a messsage to the webmaster rather than this form, .



×

Post to the Rhodes 22 Email List:



×

Sending Post:

Your post is being sent... waiting