2019-01-07; 11:29:57 EST
Member Since
2005-04-29
Posts: 816
Alexis: All the responses before mine are completely sensible. I also wonder whether the source is really the deck hatch or condensation. Pouring water on the hatch would tell you if it is leaking. Further, you would want to know if the leak is between the outside of the port and the deck hole or the inside where it is threaded. If it leaks around the outside then, as others suggest, rebedding is what is sufficient - provided, of course that you can get it out of the deck hole without destroying it. If silicone was used it should not be difficult to remove and also would likely explain why it is leaking. If something like 5200 was used, you might need dynamite to get it out. If the port is leaking internally, replacement is probably the best choice. If the leak is around the outside seal be sure to check your core material incase water has been entering the core and doing its nasty work. In any event I would strongly recommend that you seal the core edge very well with epoxy and not rely solely on sealant. By the way, I like to use butyl tape rather than sealant in such places if there is any possibility that you might need to remove the hatch again in the future. As for the coaming frame, if you can't get one from Stan or anyone else you might do what I did and install edge trim such as this: https://www.amazon.ca/gp/product/B00KGAKG2G/ref=oh_aui_detailpage_o06_s00?ie =UTF8&psc=1 . Note that is the Canadian Amazon site and you would want to look it up on the US site. The frame would certainly look much better if you can find it. Graham Stewart Agile 1976 Rhodes 22 Kingston OntarioSee the original archive post