The Rhodes 22 Discussion Group R22 Discussion Group

The Rhodes 22 Discussion Group


< prior

Back to Month

Go to Thread

Member Picture

Graham Stewart



Where to find parts?

2019-01-07; 15:18:10 EST

Member Since

2005-04-29

Posts: 816

Alexis:
The cracks are definitely a sign that the port needs to be replaced. 

I would suggest that you try to drill into the core from inside the hole to
see how deep the water has penetrated. Hopefully not far. The holes will
also allow the core material to dry out faster and allow for the epoxy to
penetrate further if you use a syringe. If the damp wood does not go too
far, I would use something like a dremmel tool to remove it and then seal
with epoxy and fill with thickened epoxy. 

If the wood is wet further in than what you can remove you might have a more
involved repair on your hands. In that case I would drill up through the
liner in a pattern of holes that fan out from the hole until you hit dry
wood. Drill lots of holes where the wood is wet. You now need to let it dry
out. Test for dryness with new holes. It might take a long time unless you
can figure out a way to push warm air into the core. I used a shop vac for
this purpose.  You would then need to figure out a way to inject epoxy into
the core without it all running back out -perhaps with tape. When I did mine
I drilled the holes from above because I knew I was going to glass and paint
the whole deck anyway. That meant that the epoxy didn't drip through. It
might still be easier even if you have to patch a section of the deck.

I had a leak around a holding tank vent in my dick. I actually removed the
deck and separated the liner and removed the core plywood - something that
turned out to be unnecessary. My point in telling you this is that when I
got to examine the plywood I found that while the hole for the vent was only
about 1/2" in diameter, the wet plywood extended out about a foot. If I had
sealed the edge of the plywood at the hole when it was dry I would have
sealed in all the water-infused plywood that was further in.

Hopefully you caught the leak early on and none of this is necessary.


Graham Stewart
Agile 1976 Rhodes 22
Kingston Ontario




See the original archive post
×

Message to Webmaster:

To use your email application to send a messsage to the webmaster rather than this form, .



×

Post to the Rhodes 22 Email List:



×

Sending Post:

Your post is being sent... waiting