The Rhodes 22 Discussion Group R22 Discussion Group

The Rhodes 22 Discussion Group


< prior

Back to Month

Go to Thread

Member Picture

Mike Riter



Trailer Rebuild

2019-02-21; 17:17:44 EST

Member Since

2018-03-19

Posts: 105

I just finished refitting my Triad as well and agree, Michael is really great to work with. My 1989 via 2018 recycled Rhodes came with a Triad single axle trailer and after getting the boat home noticed one of the hubs was smoking.. Wheel bearings were shot, which started the whole ball of wax rebuild. After pulling the wheel, I saw the seal was missing, the bearings were full of water (so it was steam not smoke) and the brakes were covered in oil. 
 
New seals (both wheels were bad), inner and outer bearings and lots of brake cleaner got that part done. The wheel cylinders for both brakes were leaking, so a rebuild of those was in order. After finishing that I filled the master cylinder with new fluid and watched it run right back out the piston seals. I thought about a rebuild kit but the surge brake head was in pretty bad shape so in went a new one. Brakes work again! 
 
Last time I put it in the water, I noticed the carpet on one of the bunks was rubbed through and the boat would not center properly when loading it on the trailer. On steeper ramps it would hit the cross bar at the front of the centering posts. Maybe I wasn't putting it in deep enough. Anyway I decided to fix all of that as well. A 10" roller between the posts solved the cross bar issue. New carpet for the bunks installed with SS staples came out really nice. Kudos go to my fiance, Brigit for all the nice detail work on that. The centering issue was a little tougher. After a lot of measuring and head scratching, I took two 4' pieces of pressure treated 2x6" pine and cut the ends on a 60 deg angle and the long top edge on a 45 deg angle. Then I drilled, counter sunk and installed 10 carriage bolts per side through the existing plastic pieces that were in place for the centering guide. Before attaching them to the plastic "boards" I wrapped them in marine carpet and stapled in place. Everything was bolted down using all new hot dipped galvanized hardware. I measured the finished project and have 1" to either side of the keel. That should center the boat nicely. By beveling the top of the boards, the boat can drop in as it's pulled out on steeper ramps and not catch on anything. 
 
We're off to the Keys in April and I now feel confident the trailer will get us there and back. 
 
See the original archive post
×

Message to Webmaster:

To use your email application to send a messsage to the webmaster rather than this form, .



×

Post to the Rhodes 22 Email List:



×

Sending Post:

Your post is being sent... waiting