The Rhodes 22 Discussion Group R22 Discussion Group

The Rhodes 22 Discussion Group


< prior

Back to Month

Go to Thread

Member Picture

Mark West



Floor Board Removal and Repair

2019-04-15; 12:05:17 EDT

Member Since

2017-11-08

Posts: 133

I saved the original gasket cleaned it with Acetone then used a gasket sealer fender washers lock nuts all stainless steel tightened bolts center out about 4 times increasing torque each time also wile here cleaned and painted center board trunk and cap also good time to replace pivot pin  I made one from a solid 316 SS have lathe helped replace lifting line  



IMG_1296.JPG

IMG_1289.JPG

IMG_1290.JPG
See the original archive post
×

Message to Webmaster:

To use your email application to send a messsage to the webmaster rather than this form, .



×

Post to the Rhodes 22 Email List:



×

Sending Post:

Your post is being sent... waiting