The Rhodes 22 Discussion Group R22 Discussion Group

The Rhodes 22 Discussion Group


< prior

Back to Month

Go to Thread

Member Picture

ROGER PIHLAJA



Mast Mount Issue

2019-06-10; 18:03:01 EDT

Member Since

2002-08-01

Posts: 1438

Stephan,



Besides the pivoting winch & ginpole on the foredeck, are you also using Stan’s mast crutch at the stern to raise the mast as high as possible prior to the start of the lift?  Without going into the nasty mathematical details, mast raising is a vector force problem.  From the point of view of shearing force at the mast mount/cabin roof joint, the critical time is right at the beginning of the lift.  As the lift proceeds and the mast angle gets steeper, more and more of the weight of the mast is directed down into the cabin roof, where the load is taken up by the mast compression post and there is less and less shear force on the mast mount/cabin roof joint.  The more you can lift the mast up from the stern at the start of the lift, the lower will be the initial shear force on the mast mount/cabin roof joint.  Obviously, pushing near the bottom of the mast during the lift also adds to the shearing force while contributing little to the lift; but, you already knew that!



Now that you’ve already stripped out the screw holes, I would rebuild them using epoxy thickened with fumed silica.  Be sure you drill out any rotten wood, caulk, etc before you fill the holes.  To assure a good bond to the cabin roof, first paint the inside of the holes with unthickened epoxy.  Let it soak into the sides of the holes and let the epoxy kick off; but, don’t let it completely cure.  Depending on temperature, 15-25 minutes is the appropriate time to wait.  Then, fill the holes with thickened epoxy and let it completely cure, say overnight.  You want the epoxy thickened to the consistency of peanut butter.  By not letting the unthickened epoxy completely cure before adding the thickened epoxy, you will achieve a much stronger, waterproof bond with the cabin roof.  It’s also cheap insurance against any future water intrusion into that critical joint.



Hopefully this helps.  Good luck!



Roger Pihlaja

S/V Dynamic Equilibrium



Sent from Mail<https://go.microsoft.com/fwlink/?LinkId=550986> for Windows 10



See the original archive post
×

Message to Webmaster:

To use your email application to send a messsage to the webmaster rather than this form, .



×

Post to the Rhodes 22 Email List:



×

Sending Post:

Your post is being sent... waiting